Can I Connect Rich Solar Portable Panel To Anker 757 Power Station Without Issues?
Updated 08/07/2025 | Published 07/14/2025
Question:
Can I connect my RS35FR to a power station without frying it? I’m using an Anker 757.
asked by: James
Expert Reply:
Yes, you can. You’ll just need an MC4 to XT60 cable - they are everywhere and inexpensive online. The Rich Solar Mega 200w Portable Solar Panel # RS85FR is unregulated, so the power station’s built-in MPPT controller will take care of safety and optimization.
Just double-check that your input voltage range for the power station is compatible with the 18v output of this panel. Lots of Anker and EcoFlow users use Rich Solar panels with great results.
What are you trying to power off of the station?
Product Page this Question was Asked From
Rich Solar Mega 200 Portable Solar Panel with Case - MC4 Connectors - 200 Watts
- Portable Solar Panel
- Panel Only
- Battery
- Power Station
- RV Solar Prep
- 101 - 200 Watts
- 10.1 Amps or More
- AGM
- Flooded Lead Acid
- Gel
- Lithium - liFePO4
- Rich Solar
more information >
Continue Researching
- Q&A: Can Portable Angled Solar Panel 200w RS62FR Be Used In Forest Camp Site?
- Q&A: Can Redarc BCDC Battery Charger Be Installed on 2014 Silverado with Smart Alternator
- Q&A: What is the Weight Limit for the Kuat Pivot 2 Swing Away Hitch Extender for Bike Racks when Closed?
- Q&A: What Solar Set-Up do I Need for My 24 Foot Winnebago to Charge My 2 Batteries?
- Q&A: Which Swing Away for Bike Racks Would You Say is Beefier in Design the Kuat or Swagman?
- Q&A: Recommended Replacement For A Samsung MR1032UBC RV Microwave
- Q&A: What Gauge Wire Is Safe To Use With Tail Light Converters On My Chevy Silverado.
- Article: 4-Step Guide to Installing RV Solar Power
- Article: How Much Solar Power Do I Need For My RV?
- Article: Solar Setups for Beginners (Feat. REDARC)
- Article: Calculating Portable Generator Power Needs
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
Andrew N.
8/7/2025
Hey, did you manage to connect your solar panel to the Anker power station successfully? I'm curious to know how it worked out for you, as it might help others looking to do the same!