Where is Power Mountain Tallboy Off-Road Bottle Jack Made

Question

Question:

Where is this Bottle Jack made at? Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2 to 37-3/4 Lift - 12,000 lbs Part Number: PM34FR

asked by: Robert

0

Expert Reply:

Hey Robert, Power Mountain jacks like the part # PM34FR are made in China.

expert reply by: Jameson C

0

Jameson C.

9/26/2025

Hey Robert, did knowing the Power Mountain jack is made in China help with your decision? I'm curious to see if this information was useful for others considering similar products.

Answer 1

Hey Mike! The Power Mountain Tallboy Off-Road Bottle Jack #PM34FR can be stored in that manner (with the oil plug facing up), but my contact at Power Mountain stressed that it should only be done for a short period of time, so I recommend setting it…

view full answer...

Answer 2

Hey Todd, The Power Mountain TallBoy Off-Road Jack is a single piston hydraulic jack. Designed to lift 12,000lbs with a lift range of 8-1/2" all the way up to 37-3/4". What kind of off road vehicle do you have?

view full answer...

Answer 3

Hey Dan, the Power Mountain Tallboy Off-Road Bottle Jack part #PM34FR will work great for you. It has the needed weight capacity and height to help you work on your 9,000 lb travel trailer. It is definitely safe for use with travel trailers. Are you…

view full answer...

Answer 4

There's a lot here, so let's go ahead and take these one by one, yes you can still use a plug-in portable solar kit, and as far as lithium batteries, their cost can be justified, but it's hard to give a blanket statement about worth.…

view full answer...

Answer 5

Hey Lynn, yes the Power Mountain Tallboy Off-Road Bottle Jack #PM34FR could be used to lift a fifth wheel trailer frame like you asked about. This has a height range of up to 37-3/4 inches and a 12k capacity so it would work great for you.

view full answer...

Answer 6

Hi Joe; the Power Mountain Tallboy Off-Road Bottle Jack #PM34FR starts off at 8.5" tall with a lift up to 14.25" without adding any extensions as seen in the attached photo. The shortest extension is 5" so it would extend up to…

view full answer...

Answer 7

John, I do believe we have something for you, but without any dimensions of the center cap it's going to be a bit difficult to say for sure, but from the looks of it the Trailer Wheel Center Cap Plug #AM90082 looks like it'll work. This…

view full answer...

Answer 8

Hello again Gerber; the total weight of the Power Mountain Tallboy Off-Road Bottle Jack #PM34FR is 26 lbs.

view full answer...

Answer 9

Hey Todd! At the lowest setting, the saddle of the Power Mountain Tallboy Off-Road Bottle Jack #PM34FR sits at 14" and the top of the saddle arms are at 15-3/8". I took a photo of it out in our warehouse, and while I wasn't able to get…

view full answer...

Answer 10

Hey Lynn, are you asking about the dimensions of the base of the Power Mountain Tallboy Off-Road Bottle Jack #PM34FR? If so, the base is 8 by 7 inch and this has a 12,000 lb lifting capacity so it would lift a 12k fifth wheel by the frame as well.

view full answer...

Answer 11

Hello Derek, thanks for reaching out. Yes, a 12,000 lb bottle jack like the Power Mountain Tallboy Off-Road Bottle Jack #PM34FR would be completely fine to use with that setup. You would not be lifting the full weight of the truck and camper to…

view full answer...

Answer 12

Hi Carl; the saddle attachment on the Power Mountain Tallboy Off-Road Bottle Jack #PM34FR is 3-1/4" wide at the base of it before the sides flare out. What will you be using the jack for?

view full answer...

Where is Power Mountain Tallboy Off-Road Bottle Jack Made

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching