Are Kodiak 225 and Titan 225 Couplers the Same

Question

Question:

Are the kodiak 225 calipers the same as the Titan 225

asked by: Fred G

0

Expert Reply:

Hey Fred, the Kodiak 225 caliper part # KDBC225DAC and the Titan 225 calipers are not the same but they are interchangeable. You could replace one with the other if needed.

expert reply by: Jameson C

0

Fred G.

4/3/2025

Jameson Purchased the kodiak 225 from another online retailer. It is a direct replacement for the Titan 225.

Jameson C.

4/3/2025

@FredG Good to know! I'll update this.

Answer 1

Yes, the direct replacement for your Titan 225S passenger's side brake caliper is the #K71-773-02. For the driver's side use part #K71-773-01. These brake calipers are compatible with 3,500 lb axles with 10 inch brakes, which according to…

view full answer...

Answer 2

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 3

You're certainly not the first person to ask about the Atwood 85739 master cylinder but those replacement parts are simply no longer available which means your best option truly is to replace your actuator. I completely understand this isn't…

view full answer...

Answer 4

Since we can't get the Atwood replacement shock anymore that you mentioned your best option would be to replace the actuator with a more reliable one like the Demco #DM72VR for if you have a drum brake setup or part #099-175-20 for if you have a…

view full answer...

Answer 5

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Are Kodiak 225 and Titan 225 Couplers the Same

Product Page this Question was Asked From

Continue Researching