Will Demco Kar Kaddy X Have Bumper Dragging Issues
Updated 03/27/2025 | Published 03/16/2025 >
Question:
I have a 2025 Toyota sienna and have concerns the bumper of the van may hit the ground when using the kaddy and going over bumps and down curbs, should I be concerned?
asked by: Dwight
Expert Reply:
Hey Dwight, that's a great question but since you will need to use a ball mount that allows the coupler height of the Demco Kar Kaddy X part # DM9713093 to be at 18 inches it would be tall enough that you would not need to worry about any ground clearance issues. This is of course assuming you are using the Sienna to tow a vehicle...
If instead you are worried about it dragging when the Sienna is being towed you should note that this does not sit up that high and it works great on vehicles with even lower ground clearance than your van. I attached a picture that shows how low the wheel platforms sit.
Product Page this Question was Asked From
Demco Kar Kaddy X Tow Dolly w/ Disc Brakes - Tilt Bed Frame - 4,800 lbs - Wide Tread
- Trailers
- Tow Dolly
- Wheel Decks
- 4800 lbs
- Cars/Trucks/SUVs
- Galvanized Steel
- Demco
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Looking For Replacement Ladder Receiver For Retractable RV Ladder
- Q&A: Do Surge Brakes Apply When Backing Up With Demco Tow Dolly
- Q&A: Recommended Replacement Motor For A Greystone RV Range Hood Vent
- Q&A: Parts Needed to Add Brake Controller to 2026 Ford Transit T350
- Q&A: Assembly Time for the Demco Kar Kaddy SS
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Is There Enough Clearance to Tow Fiat 500 on Roadmaster Tow Dolly
- Q&A: Is There Plug on 2022 Chevy Tahoe to Install Brake Controller
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Electric Bikes
- Article: Can You Flat Tow a MINI Cooper?
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Measure for Trailer Hitch Drop



Dwight
3/27/2025
Thank you Jameson and exactly the answer I was hoping to hear.....