Amp Draw On Command Electronics LED Trailer Light w/ Reflector
Updated 10/30/2025 | Published 02/18/2025
Question:
What is the wattage/amperage ratings for this light on the full brightness setting?
asked by: Alex D
0
Expert Reply:
Hi Alex; according to Command Electronics the amp draw on the LED Trailer Light w/ Reflector # 328-003-6016 is 0.45 amps when fully illuminated. If you have any other questions feel free to reach out in the comments below.
expert reply by:
Robin H
0
LED Trailer Light w/ Reflector
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
LED Trailer Light w/ Reflector - Brake, Tail, Turn - Submersible - Surface Mount - Oval - Red
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Surface Mount
- Non-Submersible Lights
- LED Light
- 7-1/2L x 3-1/4W Inch
- Red
- Command Electronics
more information >
Continue Researching
- Shop: LED Trailer Light w/ Reflector - Brake, Tail, Turn - Submersible - Surface Mount - Oval - Red
- Search Results: command electronics trailer lights
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: What's the RV Designer Motorhome Entrance Door Lock w/ Deadbolt RD68SR Made of?
- Q&A: Replacement Fireplace For The Greystone F2655BCFW Fireplace
- Article: Trailer Lighting Requirements
- Q&A: AL-KO 7230 Hub and Brakes Replacement Parts
- Q&A: Replacement Trailer Tail Light for a DOT SAE A216S2T2L 18
- Q&A: Trailer Wheel Torque Spec Chart
- Q&A: Replacement Tail Lights For 2000 Wanderer Fifth Wheel Trailer
- Article: Trailer Wiring Diagrams
- Article: How to Measure a Trailer Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
Robin H.
10/30/2025
Hey Alex, did that 0.45-amp draw on full brightness give you the info you needed for your trailer light setup? Knowing how it worked out could help others trying to match their lighting load.