Which Furrion Chill Cube Parts are Needed to Replace 3 Ducted AC Units

Updated 03/06/2025 | Published 02/07/2025

Products Featured in This Question

Furrion Chill Cube Variable Speed RV AC System w/ ADB & Thermostat - 18K Btu - Ducted - Black - R32

(131)

$1199.00

Thermostat for Furrion Chill Cube Ducted RV Air Conditioners - Single Zone

(39)

$82.10

Question:

I have currently 3 a/c units on 5th wheel and they are fully ducted systems. The air to cool is ducted and the return air is ducted as well. I dont have the large square on ceiling. Would this unit work with out the large ceiling mount distribution box and use my return air vents?

asked by: Jeremy D

Expert Reply:

Hey Jeremy, thanks for reaching out!

It looks like Furrion offers this in a variety of options. The Kit # FR49TD you're talking about includes the plenum, so you'll just need to add the Thermostat # LC74DX and you'll be good to go!

Some things to keep in mind are that these aren't compatible to work together as 1 unit so you'll need a thermostat for each unit, and then there will need to be some direct wiring done so if this isn't something you've done before or are comfortable with, you'll need to have a professional do the installation for you.

expert reply by: Jon G

Jeremy D.

2/10/2025

Yes they all have a separate thermostat now , it’s just the duct work. Each one now will cycle on and off separately. I basically think I need 3 units and 3 thermostats , and where they just mount on the roof and blow into my duct work.

Jon G.

2/10/2025

@JeremyD These parts will work for you then! Just need 3 of each and you'll be good to go.

Jeremy D.

2/10/2025

@JonG will this thermostat control my propane heater ?

Jon G.

2/10/2025

@JeremyD There is a connection point for a furnace to the thermostat, so yes.

See All (5) Replies to Jeremy D. ∨

Mike R.

3/3/2025

Jon G Sorry to highjack this thread but I also have a 5th wheel with the Coleman whisper setup without an ADB. You mentioned these will work without the Furrion ADB if you directly wire it ? Can you elaborate more on that please ? It appears the thermostat harness plugs directly into the control box and that only comes with the ADB. Would you have to find another 12vdc source to provide power for the thermostat as that usually comes from the control box ? I considered buying the ADB just for the control box to make it work? I called Lippert technician support and was told it will not work without the ADB.

Jon G.

3/6/2025

@MikeR No worries, thanks for reaching out! We've had a little confusion with all of this so I reached out to my contact at Furrion and they did confirm that the plenum will be needed and that there also needs to be 3-6" of rooftop thickness for proper installation. They said without the plenum there could be some functionality concerns, so I updated the initial post to include it. Thanks again for reaching out!