Replacement Converter Section Needed For A Progressive Dynamics # PD4060K Power Center
Updated 11/17/2025 | Published 12/13/2024
Products Featured in This Question
Question:
2017 Jayco Greyhawk 29ME. Build sheet tells me I have a PD4060K. Im interested in this converter as we are installing a LiFeP04 battery. What Im concerned about is we have one panel for AC breakers and another smaller one a few inches away for DC fuse panel. There are no part numbers in the panels. Will the new converter still fit?
asked by: Jamie H
Expert Reply:
Hey Jamie,
If you do have a Progressive Dynamics # PD4060K then you'll want to remove the faceplate and take on look at your current converter's circuit board. If you see a black and white switch or the white plastic pronged piece sitting next to the switch in the picture below then you still have a way to switch to lithium mode.
If you have the switch you can just flip it inward to switch over. If you have the older prong style you'll just need to pull the black jumper off and move it onto the "LI" and center prong. If you don't see either on yours you can switch to the # PD4560LICSV, which is a direct replacement and lithium compatible.
It's totally normal for the AC and DC distribution panels to be right next to each each other. The converter pulls power from the AC side when you're hooked up to shore power and then powers the DC distribution panel and recharges your battery.
(click to enlarge)
Product Page this Question was Asked From
Replacement Converter Section for Progressive Dynamics Inteli-Power 4000 Series 60 Amp Power Center
- Accessories and Parts
- Power Converter
- Converter Section
- 60 Amp
- Progressive Dynamics
more information >
Continue Researching
- Shop: Progressive Dynamics 4000 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel - 60 Amp
- Search Results: rv power converter
- Shop: Replacement Converter Section for Progressive Dynamics Inteli-Power 4000 Series 60 Amp Power Center
- Shop: Progressive Dynamics 4000 Series Mini RV Converter w/ Charge Wizard and AC/DC Distribution Panel
- Search Results: speakers
- Search Results: rv door locks
- Search Results: rv refrigerators
- Search Results: progressive dynamics pd4045ka
- Search Results: aluminum battery boxes
- Search Results: 12 volt battery disconnect switch
- Q&A: Can the Converter Section of a PD4045KA Be Upgraded to 60amps and Charge Lithium Batteries
- Shop: Replacement Converter Section for Progressive Dynamics Inteli-Power 4000 Series 45 Amp Power Center
- Shop: RV Designer Baggage Door Lock w/ Plastic Plunge - Black
- Q&A: Replacement Converter Section for Progressive Dynamics PD4060K for Lithium Batteries
- Shop: Norcold Polar N7X RV Refrigerator - 7 Cu Ft - AC/LP
- Shop: RhinoFLEX Rhino Blaster Adapter for Rinsing RV Holding Tanks and Sewer Hoses
- Q&A: How to Use Lithium Batteries With a PD4060K Converter/Panel That Does Not Have the Li Switch
- Video: Review of Progressive Dynamics - RV Converters - PD4060CSV
- Video: Progressive Dynamics 4500 Series Inteli-Power Converter: The Breakdown
- Video: Review of Progressive Dynamics RV Converters - Replacement Converter Section - PD4045CSV
- Video: Breaking Down the Ventline Ventadome Trailer Roof Vent
- Video: In-Depth Review of the Ventline Ventadome Trailer Roof Vent
- Video: Ventline E-Z Lift Ventadome Trailer Roof Vent Feature Review
- Video: Ventline RV Vents and Fans BVC0573-41 Review
- Q&A: Do I Need to Install a Jumper Wire On the H4 Connector When Switching From Lead to AGM Batteries?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Shop: Trailer Hitch
- Q&A: Lithium Compatible Converter To Replace WFCO WF-9855
- Shop: Trailer Wiring
- Article: What are the Common Types of Propane Fittings Used on RVs?
Heather A.
11/17/2025
Hey Jamie, how did things go with your converter setup on the Greyhawk after checking for the lithium switch or jumper? Knowing what you found could help others upgrading to LiFePO4 batteries in a similar setup.