Is Weld-On Bracket For Fulton F2 Swing-Up Jack Made Of Aluminum Or Steel
Updated 06/04/2014 | Published 06/03/2014
Question:
F1413120334 fulton trailer jack. I need to know if the weld on bracket is aluminum or steel? Thanks you
asked by: Dan
0
Expert Reply:
I spoke with my contact at Fulton and they told me that the weld-on bracket, part # F500277 for the Fulton F2 Swing-Up Trailer Jack, part # F1413100334, is made of steel. The jack has anodized aluminum alloy tubes which will be corrosion-resistant. This jack has a lift height of 10 inches and will work on trailer tongues that measure 4 X 5 inches.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Weld-On Mounting Bracket and Hardware for Fulton Swing-Up Trailer Jacks with 3" x 4" Mount
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Brackets
- Fulton
more information >
Continue Researching
- Q&A: Replacement Bearings and Brake Assemblies For 1998 Dexter 9000lb Axle
- Q&A: Recommended Mounting Bracket For Fulton F2 Jack
- Q&A: Which Solar Panel Should I Use to Keep Battery Charged That Runs Trailer Jack
- Q&A: Troubleshooting LED Trailer Lights that Flicker When Vehicle is Off
- Q&A: Will Roadmaster Comfort Ride Shock Absorbers Work on Trailer with Flipped Axles
- Q&A: Depth of Dexter Hydraulic Jack from Bracket To Outer Edge of Pump Enclosure
- Q&A: Will Dexter Self-Contained Hydraulic Jack Fit Dump Trailer
- Article: Boat Trailer Guides: Which are the Best?