Trouble Pairing Furrion Side View Cameras With Rear View Camera System
Updated 11/10/2024 | Published 11/07/2024 >
Products Featured in This Question
Question:
I just installed new Furrion side marker light cameras, FR28NR and FR85MR. The marker lights are working and the blue light is on for both units. They will not pair. I have tried holding the pair button for 2 seconds as the trouble shooting guide states then 5, 10, and 15 seconds with the same result on both. The rear camera works fine so it cannot be a distance problem. Any suggestions?
asked by: Wade E
Expert Reply:
So you likely have one of 2 issues. First if you have the 4.3" monitor it will only pair with one camera and you would need either the 5" # FR97FR or 7" # FR47FR to pair with the additional cameras. Also it could be you do not have the current Vision S and instead have an older camera system which uses a different pairing system.
Product Page this Question was Asked From
Replacement RV Side Marker Light Camera w/ Night Vision for Furrion Vision S System - Passenger Side
- Accessories and Parts
- RV Camera System
- Camera
- Side Camera
- Furrion
more information >
Continue Researching
- Search Results: tpms
- Search Results: level sensor
- Search Results: rv camera system
- Shop: ADVANTAGE 4-Point Ground Control - LCD ELECTRONICS KIT
- Shop: Furrion Vision S+ Wireless RV Backup System w/ 1 Camera - 7" Screen
- Search Results: tops
- Search Results: wireless camera
- Search Results: ground control 30
- Video: Review of Furrion RV Camera System - Vision S Plus Wireless Observation System - FR64AD
- Search Results: i beam bracket
- Shop: Furrion Vision S+ Wireless RV Observation Cameras w/ LED Marker Lights - Quantity 2
- Shop: Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Shop: Furrion Vision S+ Wireless RV Observation System w/ 3 Cameras - 7" Screen
- Shop: TireMinder i10 TPMS for RVs and Trailers w/ Signal Booster - 4 Flow Through Tire Sensors
- Video: Review of Lippert Camper Jacks - Replacement Wiring Harness - LC178278
- Q&A: Replacement Wiring Harness For Controller On The Lippert Ground Control Leveling System
- Shop: Voyager WiSight 2.0 Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 7" Screen
- Shop: Trailer Hitch
- Shop: Fifth Wheel Hitch
- Q&A: Can 4.3 inch Furrion Vision S Monitor be Replaced with 5 inch or 7 inch
- Q&A: Replacement Side Marker Camera For An RV Camera System
- Shop: Towing Mirrors
- Q&A: Side Marker Camera Recommendation For A 2022 Jayco 166FBS That Is Prepped For Side Cameras
- Q&A: Troubleshooting Non-Working Furrion Cameras After Replacing A Side Marker Camera
- Q&A: Is The Trigger Wire Required For Furrion Vision S Side View Cameras?
- Q&A: Replacement Compartment Door Slam Latch for 2021 Dutchman Atlas
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How Does a Trailer Hitch Coupler Work?
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Accurately Measure Trailer Leaf Springs


Wade E.
11/8/2024
I have a 7” monitor MN# FOSO7TADS purchased in 2020. Will the 7” monitor FR47FR pair up with my existing rear camera or will I need to upgrade the rear camera?