Replacement For Kwikee Step Switch Control Unit

Question

Question:

I need a replacement magnet door sensor for my Kwikee stairs on my 2000 Fleetwood Bounder. There are 2 that seem to fit and I am not sure which one I need. The QandAs give me mixed info. I just bought a new motor that was model number LC379608, if that helps. Based on your pictures it does appear I need an open switch, but that leaves LC301694 or LC369299. With this info, can you tell me which one I need? Thanks!

asked by: Randall S

0

Expert Reply:

Hi Randall,

So the switch is going to depend on the control unit you have; is it an all-black IMGL control unit? Can you describe what your current switch looks like by chance?

expert reply by: Kyle S

0

Randall

9/27/2024

Hi Kyle. The control unit is in a black case. The current magnets are black in color. Small, rectangle. Does that help? i can send pics too, if you need them. Thanks.

Kyle S.

9/30/2024

@Randall It does, and what you'll need for that is the Replacement Magnetic Door Sensor for Kwikee Electric RV Steps # LC369299.

Answer 1

Hi Collin, welcome back! The most economical replacement is going to be from Advent Air. You will need a complete system since everything moved to R32 refrigerant. If your upgraded thermostat is R32 compatible, or a smart thermostat that got a…

view full answer...

Answer 2

Hey Carl, we do sell the replacement door magnet sensors you are looking for which tell your power steps when you have the door open and closed. We have two options for the magnets you may need. We have the part #LC301694 and #LC369299 with the…

view full answer...

Answer 3

Hey Bradley, thanks for reaching out. We do have a replacement for the Kwikee step controller 776367. Here is the exact part you will need: - Replacement Control Module for Kwikee Electric RV Steps #LC34AF This is a direct replacement for the 776367…

view full answer...

Answer 4

I have three seals with the 2.125 inner diameter. The Grease Seal, item #21325, the Grease / Oil Seals 10-10 (Pair) - Double Lip Seals, item #RG06-090 and the Grease Seal GS-2125DL. The #21325 grease seal has an outer diameter of 3.269 inches and is…

view full answer...

Answer 5

Since Atwood is no longer in the landing gear business it is basically impossible (unfortunately) to get just a replacement leg. The part number that you gave me actually is a document that shows the various parts for Atwood landing gear, but nobody…

view full answer...

Answer 6

It sure will Johnathon and thanks for the pics! The Replacement Magnetic Door Sensor item #LC369299 is designed specifically for Kwikee series 32 steps. It comes with new magnets and a fresh wiring harness. The more expensive one you referenced is…

view full answer...

Answer 7

Hey Robin! Are you looking for a complete flat tow setup, or do you already have some parts of the system? For baseplates and tow bar, I'd go with Roadmaster Direct-Connect Base Plate Kit - Removable Arms #RM-522203-5 and the Roadmaster Nighthawk…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Replacement For Kwikee Step Switch Control Unit

Product Page this Question was Asked From

Continue Researching