Can Continuous Steel Piano Hinge # H300 be Cut to Length Needed
Updated 05/19/2014 | Published 05/16/2014
Question:
I am make cabinets for my enclosed trailed and going to use the continuous hinge on the doors and need to knew if the continuous hinge can be CUT to the size I need them? THANK YOU
asked by: George B
1
Helpful Expert Reply:
Yes, you can cut the hinge, # H300, to the size you need with the proper equipment. An angle grinder with a cutting wheel would be a good choice to cut the hinge. We have other hinge options if you are interested. I have linked them for you.
expert reply by:
Michael H
1
Product Page this Question was Asked From
3" Wide Continuous Hinge - 6' Long - Steel
- Trailer Door Hinges
- Piano Hinge
- Non-Removable Pin
- Steel
- 72 Inch Long
- 3 Inch Wide
- Bolt-On
- Weld-On
- Polar Hardware
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Installation of Rubber Hollow Bulb Seal for RV and Trailer Door
- Q&A: Parts Needed To Add a Factory Style 4/7-Way Connector On a 2022 Ford Bronco With LED Tail Lights
- Q&A: Can MaxxFan Dome Plus Roof Vent be Installed on Side Wall of Trailer
- Q&A: Replacement 12" Brakes for Fayette Dayton 9254 W-5 Axle
- Q&A: Determining If We Have A Replacement For A Dayton Fayette 9254 Hub and Drum Assembly
- Q&A: Availability of a Stainless Steel T-Handle
- Q&A: Dimensions of T-Handle Locking Stainless Steel Flush Door Latch # L4080
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Lighting Requirements
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Determining Trailer Tongue Weight