What Wheel Pilot Diameter Does Phoenix USA Rear Wheel Center Cap Fit

Updated 02/03/2026 | Published 07/23/2024

Question:

I have a 2014 Thor Palazzo 33.2. Just put aluminum wheels on the rear axle but now part of the hub shows. Are these made to go on after the wheel is mounted? Do the clips hold it in place around the hub? Thanks, Brent

asked by: Brent H

Expert Reply:

Hey Brent, so the wheel center cap part # PXQ247 that you referenced could potentially work for you but you'll have to double check your dimensions. The one picture you sent with the tape measure doesn't have the end of it on the end of the center cap so it's not super helpful unfortunately. This is designed to fit between the wheel and the hub so your wheel would have to come off and push this in behind the wheel center.

This cap was designed to fit a wheel center bore of 8-1/4 inches and is 9 inches tall.

expert reply by: Jameson C

Jameson C.

2/3/2026

Hey Brent, did the wheel center cap end up fitting your Thor Palazzo once you checked the dimensions? Knowing how it matched up with your aluminum wheels could help others working on a similar setup.