Replacing Trailer Leaf Spring With 25-1/2" Measurement Bolt Hole To Bolt Hole
Updated 07/15/2024 | Published 07/06/2024 >
Question:
Im looking at replacing both 1-leaf on my trailer. The current ones measure 25 1/2. Im guessing thats do to being under load for over 6 years. Im going to replace them with your 1-Leaf Double-Eye Spring for 6,000-lb Trailer Axles - 25-1/4 Long. Does this sound right or is there a 25-1/2 leaf.
asked by: Mike
Expert Reply:
Hey Mike, you are correct in ordering the 1-Leaf Double-Eye Spring for 6,000-lb Trailer Axles - 25-1/4" Long # e46SR. In order to measure your current worn out leaf springs, you should lift the trailer off the ground to take away any strain on the suspension and measure from bolt eye to bolt eye. If this is what you did and you came up with 25-1/2", then 25-1/4" # e46SR is definitely what I would go with. It is very usual for leaf springs to measure slightly over the factory length after getting worn out.
Product Page this Question was Asked From
1-Leaf Double-Eye Spring for 6,000-lb Trailer Axles - 25-1/4" Long
- Trailer Leaf Springs
- Double Eye Springs
- 9/16 Inch Eye
- Bushing Not Included
- 6000 lbs
- 1-3/4 Inch Wide
- 1 Leaf
- 25-1/4 Inch Long
- Standard Grade
- etrailer
more information >
Continue Researching
- Search Results: 7 pin trailer connector
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Search Results: boat trailer electric brakes
- Article: How to Accurately Measure Trailer Leaf Springs
- Shop: Trailer Wiring
- Article: How to Tell the Weight Rating of a Trailer Axle
- Video: etrailer Rust-Resistant 4-Leaf Slipper Spring for 4,300-lb Trailer Axles Review
- Search Results: trailer spring kit
- Search Results: bearing buddy
- Q&A: Electric Brake Compatibility on a Boat Trailer
- Search Results: electric brake wiring
- Search Results: springs
- Shop: Suspension Enhancement
- Video: An In-Depth Look at the 1-Leaf Double-Eye Spring for 6,000-lb Trailer Axles
- Search Results: electric over hydraulic actuator
- Shop: Dexter Trailer Hub & Drum Assembly for 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 - Pre-Greased
- Shop: Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles - 10" - 5 on 4-1/2 - Pre-Greased
- Shop: CE Smith U-Bolt Kit for Mounting 2" Square Trailer Axles - 4-1/2" Long U-Bolts - Zinc
- Shop: Electric Trailer Brake Assembly - Dacromet - 12" - Right Hand - 5,200 lbs to 7,000 lbs
- Shop: etrailer Rust-Resistant Electric Trailer Brakes - Dacromet - 12" - Left/Right Hand - 5.2K to 7K
- Q&A: Can Electric Brakes be Used on Boat Trailer
- Shop: 3-Leaf Double-Eye Spring for 2,500-lb Trailer Axles - 25-1/8" Long
- Shop: Taylor Made Adjustable Handles for Boat Side Windows
- Q&A: Can a 4-Leaf Trailer Leaf Spring be Used in Place of a 3-Leaf Spring
- Q&A: Can I Use Heavier Rated Leaf Springs on Trailer Without Causing Damage
- Q&A: Difference Between 3 and 4 Leaf Spring Stack for 3,500 Pound Axle
- Q&A: Is Bushing Required on Open Eye End of Slipper Spring
- Q&A: Is it Ok to Replace Factory Leaf Springs With a Higher Capacity Option?
- Video: Hands-On with the 3-Leaf Double-Eye Spring for 2,500-lb Trailer Axles
- Video: 4-Leaf Double-Eye Spring for 4,000-lb Trailer Axles Spec Review

