Availability of 6 Leaf RV Door Hinge Kit that is Non-Friction

Question

Question:

I have a 2021 Alliance Valore fifth wheel looking for door hinges that are non-friction they are six leaf

asked by: Mark B

0

Expert Reply:

Hey Mark, the Lippert hinge kit part # LC198295 that you referenced is exactly what you are looking for. This is a 6-leaf hinge setup that is the non-friction style like you asked about as well.

expert reply by: Jameson C

0

Bc

4/26/2026

I'm looking for a NON-friction 6 leaf hinge with the screen door hinge on the end. Is there such an animal out there? The only ones that keep surfacing are screen hinges in the center.

Jameson C.

4/27/2026

@Bc Would the part # LC198295 work? It's a 6 leaf hinge setup with no friction built in.

Answer 1

The hall power short error you are seeing is describing an issue where one of the wires on your hall effect jack/actuator which measures travel is shorting to a ground circuit. This is most likely along the wire on your camper but it could also be…

view full answer...

Answer 2

A typical RV entry door gas strut ranges from 10-20lbs in pressure. We carry both a 10lbs #372-5300-10 and 20lbs #372-5300-20 that you can use. Really it just comes down to preference and the climate. If you're in a windy climate going heavier…

view full answer...

Answer 3

Hey Tim, yes you are going to need to cut off the old chain or cut off the loop that is welded to the trailer frame so you can install a new 24 inch safety chain like the part #TCTSCG30-724-03x1. I would cut the chain though so that you can reuse the…

view full answer...

Answer 4

The Replacement Entry Door Hinge for RV #LC198295 that we offer is only 9-1/4" long x 2-1/8" wide, but you would still be able to use this hinge anyway. You'll need to drill out the rivets holding your current hinge in place then fill…

view full answer...

Answer 5

Hey Joseph, welcome back! I have two 6 Leaf friction door hinges, however they're only 9-5/8" long. They are the Replacement Hinge for RV Entry Door - 6 Leaf - White item #LC22NJ or item #LC95VR in black. These have the controlled motion…

view full answer...

Answer 6

Thanks for your question Arnie. All of the base plate kits we carry for the 2026 Ford Maverick Hybrid require some modification to the lower active air shutter system. After comparing the installation instructions, the etrailer Invisible Base Plate…

view full answer...

Answer 7

Hi Randy, Adding base plates to your 2025 Ford Maverick will not void your warranty. While you'll need to be really mindful during installation, it's possible to install the base plates without causing any issues. Modifying the lower shutters…

view full answer...

Answer 8

Hello Shawn, thanks for reaching out. Yes, a lot of times door hinges are riveted on from the factory, but if you need to replace one, they don't have to be riveted. You can use screws or bolts and nuts, and they will work just fine. If you want…

view full answer...

Answer 9

Hey Allen, welcome back! For the Kodiak 225 calipers with 10-inch rotors, mount the calipers behind the axle on both axles. That's the standard installation and is how Kodiak designed the brackets to be used. Looking at the trailer from the…

view full answer...

Answer 10

Hey Steven! The Replacement Entry Door Hinge #LC198295 will fit your 2008 Keystone Fuzion. These are pretty much universal, and often used to replace the older 4-leaf hinges. The only thing we really can't guarantee is that the holes will line…

view full answer...

Answer 11

Hey Teresa, The Replacement Entry Door Hinge #LC198295 has a 9 1/4" overall length so it sounds like it'll be too tall for what you need. For something shorter, we have the 5-Leaf alternative that comes in Black #LC85TX or White #LC25TX and…

view full answer...

Availability of 6 Leaf RV Door Hinge Kit that is Non-Friction

Product Page this Question was Asked From

Continue Researching