Does Truck Bed Camper Need To Hang Over Truck Bed Rails For Brophy Hand Crank Jack To Work?
Published 05/21/2024
Question:
Is camper overhang required for the jacks to work?
asked by: Nickie
0
Expert Reply:
Yes, technically the camper needs to hang over truck bed rails for the Brophy Heavy Duty Cable Camper Jacks - 67" Max Lift Height - 4,000 lbs # CJ31 to get under the camper and lift it up properly. This should be self-explanatory, but if the camper doesn't fit the truck bed properly and doesn't overhang the proper amount, then the jack would be too close inside and possibly hit the truck tires.
expert reply by:
Andrew N
0
Product Page this Question was Asked From
Brophy Cable Camper Jacks - 57" Max Lift Height - 1,000 lbs - Qty 2
- Camper Jacks
- Truck Camper
- Tripod Jacks
- Steel
- 1001 - 2000 lbs
- Manual Jack
- 57 Inch Lift
- 2 Jacks
- Brophy
more information >
Continue Researching
- Q&A: How To Determine If The Brophy Cable Camper Jacks Will Work For Me
- Q&A: How Much Fender Clearance Does The Brophy Heavy Duty Cable Camper Jacks Offer
- Q&A: Will the Brophy Cable Camper Jacks Work On A Camper That Does Not Extend Past Bed Sides
- Q&A: What Is The Difference Between Brophy Cable Camper Jacks CJ31 and CJ41?
- Q&A: Replacement for Older Happijac Truck Bed Camper Jack
- Q&A: Are The Brophy Cable Camper Jacks Stable
- Article: How to Mount a Truck Bed Camper
- Q&A: Recommendation of Camper Tie Downs for a 2010 Ford F-150
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Converting Your RV Water Heater to Tankless
- Article: Flat Towing Package for 1998-2006 Jeep Wrangler
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Best RV Roof Vents