Width of Separation On Mounting Holes For Curt Trailer Hitch Receiver # 13040
Updated 05/21/2024 | Published 05/19/2024 >
Question:
I was wondering what the width was from the center bolt holes to each other
asked by: Todd
0
Expert Reply:
The Curt Trailer Hitch Receiver # 13040 has the mounting holes located closer to the front of the vehicle separated 40" on center. While the holes near the rear bumper are spread 39-3/4" on center. I have included an image below to help show you these measurements.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Availability Of 2" Trailer Hitch Receiver For 1989 Geo Tracker
- Q&A: Heavy Duty Hitch Receiver for 2008 Chevy Express 3500 Cutaway Shuttle Bus
- Q&A: Is There An Auto-Level Upgrade for Power Gear 500731 Key Pad
- Q&A: What Trailer Wiring do I Need for My 2020 Highlander without Factory Tow, with Connectors?
- Q&A: Measurements from Bolt Holes Center to Center for the Curt Hitch #13040 2008 for Chevy Express Van
- Q&A: Brake Controller Wiring Harness on 2026 Ford F-250 WT
- Q&A: How To Install 7-way Connector On 2010 Chevy Express Van 3500 Without Factory 7-way Connector Plug
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Choose the Right Trailer Hitch Class
- Article: Types of Trailer Hitches: How and Why to Use Each
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: Brake Controller Installation: Starting from Scratch


