Is there a Way to Replace Slide On Demco DA91 Disc Brake Actuator For No Coupler Drop?
Updated 05/17/2024 | Published 05/15/2024
Products Featured in This Question
Question:
8750411 bought for my boat trailer . Unfortunately I found out after all was hooked up and tested that the drop hitch style was a bad idea for hooking up . Raised trail tongue height even with a 5 drop receiver. My question is can I purchase a straight tongue to put into this hitch with out any issues? And if not what would be another model that I can go to that has the disc brake style hitch with electric lock out thx
asked by: Chris M
Expert Reply:
We do have the Replacement Inner Slide # DM12808-97 you could use with the Demco Trailer Coupler # DM15791-97 on your Demco Hydraulic Brake Actuator # DM8750311. This would allow you to position the coupler at several different heights to best level your trailer.
Otherwise you would have to drill new holes for the Actuator # T4747220 which has a straight coupler out of the actuator.
Product Page this Question was Asked From
Demco Hydraulic Brake Actuator w/ Drop and Electric Lockout - Disc - Zinc - 2-5/16" Ball - 8K
- Brake Actuator
- Surge Brake Actuator
- Farm Trailer
- Boat Trailer
- Construction Trailer
- Travel Trailer
- Utility Trailer
- Bolt-On
- 8000 lbs GTW
- 2-5/16 Inch Ball Coupler
- 3 Inch Channel Tongue
- Disc Brakes
- Electric Lockout
- Demco
more information >
Continue Researching
- Search Results: disk brake kits
- Search Results: kodiak hydraulic brake line kit
- Search Results: grease~seal 10~19
- Search Results: t4839100
- Search Results: demco da91
- Search Results: safety chains
- Search Results: surge brake actuator
- Q&A: Best Replacement Options for TDE LP8000 Surge Brake Actuator (3" Tongue, 8K Trailer)
- Shop: Hydrastar Marine Electric Over Hydraulic Actuator w/ Breakaway and 7-Way RV Harness - 1,600 psi
- Shop: Dicor H.A.P.S. Free Lap Sealant - White
- Q&A: How To Install The Plug-And-Play Hydrastar Vented Marine Electric Over Hydraulic Actuator
- Video: The Low-Down on the Kodiak Disc Brake Kit-K2HR35DKG
- Shop: Kodiak Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet and KodaGuard - 3,500 lbs
- Video: Replacing the etrailer L44649 Trailer Hub Bearing
- Q&A: Replacement Actuator for Tie Down TDE LP8000
- Shop: Hub Saver Hub and Wheel Protector - Fits 4, 5, and 6-Lug Trailers - Qty 2
- Shop: Manual Reverse Lockout Kit for Demco Hydraulic Trailer Brake Actuators
- Shop: Demco Hydraulic Brake Actuator w/ Drop and Electric Lockout - Disc - Zinc - 2-5/16" Ball - 8K
- Shop: Kenda Karrier KR35 ST225/75R15 LRE Radial Trailer Tire w/ 15" Nardo Gray Mod Wheel - 6 on 5-1/2
- Video: Hands-On with the Replacement Master Pin for Dexter Model 6 Brake Actuator
- Video: Titan Brake Actuator T4067700183 Review
- Video: Let’s Check Out the Manual Reverse Lockout Kit for Demco Hydraulic Trailer Brake Actuators
- Q&A: Does Demco Hydraulic Brake Actuator Come With Manual Lockout Option
- Video: Detailed Breakdown of the Kodiak Disc Brake Kit
- Video: Complete Breakdown of the Bearing for Dexter Model 6 Actuator
- Q&A: Locking Out Dexter Surge Actuator to Convert to Electric Over Hydraulic
- Q&A: Can Hydraulic Surge Brake Actuator be Locked Out for Electric Brake Conversion
- Q&A: Parts Needed to Convert a Surge Disc Brake Trailer to an Electric Over Hydraulic Setup
Chris M.
5/17/2024
That replacement looks like it goes down for adjustments. I would need one to be more neutral or even go up for adjustments. If there is a like replacement. If not then the one I took off is more like the Dexter straight hitch I could go back to . Just didn’t think with drum brakes and upgraded to disc brakes that I still needed to change out actuator. But if other options plz advise thanks