Length of Handle on Ultimate Trailer Jack 322-RDJ-2K
Updated 05/15/2024 | Published 05/13/2024
Question:
Do you know what the length of the handle is for the topwind Ultimate Trailer Jack part 322-RDJ-2K? Specifically from the center of the jack to the outermost part of the crank handle. Trying to ensure that this jack will fit given the proximity of the propane tank enclosure on my trailer current jack is a side winder.
asked by: Alan
0
Expert Reply:
Hi Alan,
The length of the handle from center of the jack to the outside is 6-3/4 inches for the Ultimate Trailer Jack # 322-RDJ-2K.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Ultimate Trailer Jack - A-Frame - Topwind - 15-1/2" Lift - 2,000 lbs
- Trailer Jack
- Utility Trailer
- A-Frame Jacks
- Topwind Jack
- 1001 - 2000 lbs
- Manual Jack
- 28 Inch Lift
- Bolt-On
- Weld-On
- With Rectangle Foot
- Ultimate Jack
more information >
Continue Researching
- Q&A: Mounting Plate Dimensions and Bolt Holes on Ultimate Trailer Jack # 322-RDJ-2K
- Q&A: How Far Out Does the Pin on the Ultimate Trailer Jack # 322-RDJ-2K Stick Out
- Shop: Ultimate Trailer Jack - A-Frame - Topwind - 15-1/2" Lift - 2,000 lbs
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: Lowest-Profile A-Frame Trailer Jack For Tailgate Clearance
- Q&A: Low Profile Trailer Jack Recommendation for Better Tailgate Clearance
- Q&A: Can I Install the Square A-Frame Jack w/ Footplate e74VV in a Round A-Frame Hole?
- Q&A: How Does The Ultimate Trailer Jack Fold Up For Travel
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What RV AC Will Work With Your Setup? Avoid Costly Mistakes Before You Order
- Article: Trailer Jacks
- Article: Trailer Wiring Diagrams
- Article: Spring Towing Readiness Checklist
- Article: Brake Controller Installation: Starting from Scratch
- Article: How Much Solar Power Do I Need For My RV?