Troubleshooting Hard to Start Vehicle After its Flat Towed
Updated 05/14/2024 | Published 05/11/2024 >
Products Featured in This Question
Question:
Hi I bought and installed a Roadmaster InvisiBrake Flat Tow Brake System . When I unhook the car after traveling the car does not start easily and doesn’t want to idle, after revving the engine for a few minutes it’s ok again what’s the problem?
asked by: Teuvo K
Expert Reply:
Does it crank slowly or can you be more specific on the problems? My first thought is the battery is dying and that's why it's hard to start. This would be the case if it is slow to crank. We have a charge line kit that would help with that with the part # RM-156-25 which will help keep the battery topped off when flat towing as the braking system does slow discharge the battery.
Product Page this Question was Asked From
Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Flat Tow Brake System
- Brake Systems
- Pre-Set System
- One-Time Setup
- Vehicle Battery
- Fixed System
- Power Assist Brake Compatible
- Air Brakes
- Hydraulic Brakes
- Indicator Lights
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does Roadmaster Invisibrake Fit 2024 Jeep Rubicon
- Q&A: Will Curt RVibrake Shadow 2 Fit 2026 Ford Maverick Hybrid
- Q&A: Recommended Flat Towing Set Up for a 2026 Ford Maverick Hybrid
- Q&A: Best Flat Tow Setup For 2026 Ford Maverick XLT Hybrid
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: Recommended Parts for Flat Towing a 2025 Ford Maverick
- Q&A: Parts Needed to Flat Tow 2021 Jeep Wrangler 4xe
- Article: Must-Have Flat Towing Components
- Q&A: Comparing The Roadmaster Invisibrake And Demco Stay-IN-Play Duo Supplemental Braking Systems
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Article: Flat Towing Package for 2015-2018 Ford F-150
- Article: Trailer Wiring Diagrams


Kotoneva T.
5/13/2024
Hi I have the battery charge line and the battery disconnect switch both work fine no it starts fine but doesn’t want to idle only if I rev the engine for a while 1-2 minutes then it’s normal again I think it has something to do with the visibrake vacuum line that’s hooked up to the brake booster vacuum line.