Grommet For Replacement Regal Style Front Cover for Solera Power RV Awnings

Question

Question:

Is there a cap or cover that goes into the whole on the top right corner of part number Item LC643922? I had to replace the whole cover assembly but the hole looks like it needs a cover of some sort.

asked by: Steven

0

Expert Reply:

Hi Steven,

Yes there is a grommet for the hole you are referring to on the Replacement Front Cover for Solera Power RV Awnings - Regal Drive Head # LC643922.

Per the manufacturer, what you need is the Replacement Manual Override Grommet for Solera Powered RV Awnings # LC95ED.

expert reply by: Kyle S

0

Answer 1

Hey Larry, thanks for reaching out! Sounds like you're needing the Replacement Manual Override Grommet #LC95ED, which fits your Regal awning head style.

view full answer...

Answer 2

Hey William, The replacement manual override grommets for your Solera RV awning can be found with either part #LC95ED if you have a powered awning or part #LC299993 if you have a manual crank awning.

view full answer...

Answer 3

The replacement plug/grommet you are looking for is the Replacement Manual Override Grommet for Solera Powered RV Awnings #LC95ED. So this will be what you need to fill the hole in your awning head (even though the replacement drive head cover really…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Grommet For Replacement Regal Style Front Cover for Solera Power RV Awnings

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching