Replacement Spotlight for Horse Trailer

Question

Question:

Looking to replace exterior Spotlight on my gooseneck horse trailer. Not the running lights, but more of a spotlight Can you recommend lights at woodwork?

asked by: Tressa A

0

Expert Reply:

For a replacement light on your horse trailer I recommend the Ultra Bright LED Flood Light # 3371492196. The light is incredibly bright with a 9,000 lumen output. This is technically a flood beam so it covers a wide area but it will reach up to 679'. It is IP69K rated so it can withstand severe environmental conditions and has TCS technology to adjust brightness and optimize efficiency based on the temperature of the light.

expert reply by: Robin H

0

Tressa A.

4/21/2024

Hi Robin Thanks for the info and getting back to me. Is there a slightly cheeper option. I need to replace all 4 lights and $400+ is a little to much for me and my old trailer. Thanks

Robin H.

4/21/2024

@TressaA the # 3371492190 is the same style but not quite as bright and a little bit cheaper. I'm not sure where you're placing the four lights but unless it is one on each side you also might be able to replace two with the single brighter light to reduce replacement costs.

Answer 1

Hey Keith, The Furrion Tankless #FR93FR will fit into that cutout you have and be a good replacement. The water heater itself is 12-5/6 x 12-5/8 fitting nicely into your 13 x13 cutout. The depth of the heater itself is 19-1/4 which should fit nicely.…

view full answer...

Answer 2

Hey Samuel, thanks for reaching out! B&W has some of the bigger parts available through retailers like us, but for smaller parts they like to deal with customers directly, so they'll be able to identify any issues with their products quicker.…

view full answer...

Answer 3

You are going to need to contact B&W directly as the only way we carry the anchor bolt is on the Base #BWRVB3305 for your Companion 5th wheel hitch.

view full answer...

Answer 4

Hey Richard. welcome back! The Go Power Pure Sine Wave Inverter Charger #GP75QR does not include the display. You will need the Go Power PowerTrak Screen #GP64XR to go with it. You will also need the #GP74XR, #GP84XR, and #GP24XR to make all of your…

view full answer...

Answer 5

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Answer 6

If the two 12-volt batteries are wired in series and therefore put out 24 volts then the part #34280231 is correct since this is for a 24 volt system. If instead they are wired in parallel and put out 12 volts you'd instead need the #34279999…

view full answer...

Answer 7

We do have a grease seal that is almost exactly what you measured that should work for you, with the outer diameter being 0.06 inches off, which could very easily be explained by the amount of pressure put on the caliper. So it is very likely that…

view full answer...

Answer 8

Since you wanted the brightest flood light possible, you definitely made the right choice with the 9,000 lumen Ultra Bright LED Flood Light #3371492196, and you have it absolutely correct in regards to the two wires. They are a power wire and ground…

view full answer...

Answer 9

Yes The Ultra Bright LED Flood Light #3371492196 can be used as a backup light when connecting to your reverse blue wire from the 7 plug, but you need to make sure that the circuit can handle the power of the light. Each light runs 6.25 amps, since…

view full answer...

Answer 10

Hey Jeff, I don't see why you could use the Roadmaster diode part #RM-790 the way you mentioned. Sounds like you are looking for a way to have aux lights come on with either a remote switch from your cab or to come on anytime the high beams are…

view full answer...

Replacement Spotlight for Horse Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching