Does Amp Hour of Battery Bank Need to be Set of the Go Power RV Battery Monitor Kit GP44FR
Published 04/09/2024
Question:
I purchased this panel and I replaced my single 100AH AGM battery with 4 each 100AH lithium batteries in parallel... I replaced the solar controller, wires and fusing as appropriate. BUT this remote display shows 100 charge but it also says 100AH... Why doesnt it now read 400AH? Probably a really newbie question so apologies in advance.
asked by: Paul L
Expert Reply:
Hey Paul, you actually need to go in and set the max amp hour capacity of your battery bank in the settings of the Go Power monitor part # GP44FR. If you check out page 5 and 6 of the attached install instructions link you can see how to do this.
Product Page this Question was Asked From
Go Power RV Battery Monitor Kit with 25' Cable
- Accessories and Parts
- Battery
- Battery Monitor
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Go Power RV Battery Monitor Kit with 25' Cable
- Q&A: Can Go Power RV Battery Monitor Kit with 25' Cable # GP44FR Work on Battery Bank
- Q&A: Parts Needed to Connect Go Power PowerTrak Screen, Inverter, and Solar Charge Controller
- Q&A: Will Cummins Onan EC-AGS+ Work With Lithium Batteries
- Q&A: Does Go Power PowerTrak Pure Sine Wave Inverters Have Bluetooth Or App Monitoring?
- Q&A: 2019 Lance 1475 Lift Kit for 2-5/8 inches
- Q&A: Choosing 7-Way Connector for 2025 Ford Bronco Big Bend With Factory Wiring
- Q&A: Availability Of Antenna Extender For Furrion Vision S+ Camera System
- Article: Trailer Wiring Diagrams
- Article: Does Solar Panel Type Really Matter?
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 4-Step Guide to Installing RV Solar Power
- Article: How to Measure Your Trailer Wheel Bolt Pattern