Parts Needed to Connect Go Power PowerTrak Screen, Inverter, and Solar Charge Controller
Updated 03/04/2026 | Published 02/06/2026
Products Featured in This Question
Question:
What cables are needed to tie my solar controller, my inverter/charger, and my touch screen together so they will all talk to each other?
asked by: Brad
Expert Reply:
Hey Brad! I just went over this with Dometic/Go Power and you will need several wiring harnesses in addition to the # GP74XR you already picked up. To connect the Go Power PowerTrak Screen # GP64XR, Pure Sine Wave Inverter Charger # GP85QR, and MPPT Solar Charge Controller # GP32QR you will need the following:
-GP-RVC-PT-TR - RVC Terminating Resistor Harness # GP84XR
-GP-RVC-EXT-25 - RVC Extension Harness, 25' (the # GP74XR you have)
-GP-RVC-PT-BC - RVC Branch Connection Harness # GP88QR
-GP-RVC-BC - ADV LFP RVC System Harness # GP66QR
-GP-RVC-EXT-5 - RVC Extension Harness, 5' # GP24XR (Optional)
The parts that aren't linked are parts we don't carry right now. I have submitted them so they can be added to our site. You can't get them on the Go Power site right now apparently either because they're down for maintenance (they said it should be up in a few days). I'll follow up once we have them available.
I went ahead and attached the full list from their configurator below, along with their example wiring diagrams. If you need anything else in the meantime let me know in the comments below.
(click to enlarge)
(click to enlarge)
(click to enlarge)
Continue Researching
- Search Results: rv solar panels
- Search Results: front mount hitch
- Search Results: overlander~e~200
- Search Results: 30 amp solar charge controllers
- Search Results: mc4 cable
- Search Results: gp~rvc~r
- Video: Review of Victron RV Power Converter - Orion Tr DC To DC Isolated RV Converter - VN54RR
- Search Results: go power solar charge controllers
- Shop: Go Power RV-C Extension Harness - 25'
- Shop: Go Power Overlander Expansion Kit - 200 Watt Solar Panel
- Shop: Go Power PowerTrak Terminating Resistor Harness
- Shop: Victron SmartShunt Battery Monitor with IP65 Protection - 500 Amp
- Shop: Go Power MPPT Solar Charge Controller - PowerTrak - 12V and 24V - 30 Amp
- Shop: Victron SmartSolar 100/50 MPPT Solar Charge Controller - 12V/24V - 50 Amp
- Shop: Victron MultiPlus-II Inverter Charger with 2 AC Outputs - 2,400 Watts - 50 Amps - 12V - UL Listed
- Shop: Front Mount Hitch
- Q&A: What Gauge Wire Is Required On a 7-Way Connector
- Video: A Closer Look at the Go Power Parallel Cable for MPPT Charge Controllers
- Q&A: Can Furrion Chill Cube Operate With RV Furnace
- Q&A: Availability Of Parallel Cord For Connection Multiple Go Power! MPPT Solar Charge Controllers GP72RR
- Q&A: Can Any Wire be Spliced into Go Power Solar Panel Kit to Extend it
- Video: Review of Go Power RV C System Communication Cable - GP66QR
Robin H.
3/4/2026
Hey Brad, did you get everything connected between your PowerTrak screen, inverter/charger, and solar controller using those harnesses? Your update could make it easier for others wiring the same Go Power setup.