Does MORryde Shackle Kit Fit With Equa-Flex System

Question

Question:

Will this shackle kit fit a 2017 Grand Design Reflection fifth wheel with two 6K Lippert axles and equipped with the Lippert Equa-Flex Suspension system?

asked by: Cameron H

0

Expert Reply:

Yes, the MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 3-1/8" Long Shackle Straps # MR76ZR will fit with the Equa-Flex system on your Grand Design.

expert reply by: Kyle S

0

Answer 1

You will measure the MORryde Suspension Upgrade Kit for Tandem Axle Trailers #MR76ZR from the center of each hole on the shackle strap.

view full answer...

Answer 2

Hey Dave, the MORryde upgraded shackle kit part #MR76ZR that you referenced is compatible with your 2020 Grand Design 2670MK and the Lippert Road Armor equalizers.

view full answer...

Answer 3

The correct angle for a set of shackle straps should be about 45 degree while loaded. If you are replacing suspension components it's important that you choose options which are the same length/height as the existing so you don't run into…

view full answer...

Answer 4

The MORryde SRE4000 kits like the #MR47ZR and the #MR97ZR typically will lift the trailer suspension about 3/4 to 1 inch. It varies for most people as we have found but I looked online and most people reported between 3/4 inch and 1 inch.

view full answer...

Answer 5

You will definitely want to go with the Road Armor Shock Absorbing Equalizer Kit #LC696740 over the MORryde as the Road Armor has more travel and will provide a smoother ride. Then, in regards to shackle straps I'm not sure what you mean by which…

view full answer...

Answer 6

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

view full answer...

Answer 7

I spoke with Lippert about the mounting brackets for the Lippert On-The-Go Telescopic Ladder #LC64HD and found out that they are only sold as an OEM part. This means that only the motorhome/trailer manufacturer is able to order them so you…

view full answer...

Answer 8

Hi Alain, thanks for the question and yes, you made a very nice choice for your Grand Design Reflection 337RLS going with the MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 3-1/8" Long Shackle Straps #MR76ZR. This is a very good kit…

view full answer...

Answer 9

Thanks for the information! The Equa-Flex 145545 you have is the Equa-Flex Cushioned Equalizers - Double Eye Springs - Tandem Axle - 6K to 8K #LC279688. Since you measured your shackle straps and found they are 3-1/8" center to center of the…

view full answer...

Answer 10

The Replacement Wet Shoulder Bolt - Equa-Flex Tandem Axle Suspension - 9/16" x 2-5/16" #LC126238 has a 7/16"-20 fine thread.

view full answer...

Answer 11

For your Grand Design Momentum 320G the only hitch that would fit a 75.5" gap is the Ultra-Fab 2" Trailer Hitch Receiver for Trailer Frames Item #UF35-946403 This hitch receiver is to carry a bike rack or cargo carrier on the back of your…

view full answer...

Answer 12

Thanks for the pictures of your setup. Based on that the closest standard equalizer we have is the part #TREQ356. Which then for bolts you'd need the part #126B2 and then shackle straps part #115052 and you'd be set.

view full answer...

Does MORryde Shackle Kit Fit With Equa-Flex System

Product Page this Question was Asked From

Continue Researching