Will GloLight LED Trailer Tail Light Wire to Trailer Wires
Updated 03/20/2024 | Published 03/19/2024
Products Featured in This Question
Question:
I want to replace the tail/brake/stop lights on my 1993 boat trailer. Currently the lights just “wire up” to the harness. Will these LED install the same
asked by: Bill P
0
Expert Reply:
Hi Bill; you'll need the plug-in pigtail, but yes the GloLight LED Trailer Tail Light # STL111RB will connect to the wires on your trailer. The pigtail you'll need is the 3-Wire Pigtail for Optronics Trailer Lights # A45PB.
On this pigtail the white wire is ground, black is tail light, and red is turn signal.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
GloLight Halo LED Trailer Light - Brake, Tail, Turn - Submersible - Oval - Red
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Recessed Mount
- Submersible Lights
- LED Light
- 6-7/16L x 2-5/16W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Q&A: What Info is Needed to Pick Out Cushioned Equalizers for Jayco Bunkhouse
- Q&A: Replacement Composite Latch Handle for Demco eZ-Latch Trailer Couplers
- Q&A: What's Needed To Upgrade From 5,200 Lb to 7,000 Lb Trailer Axles
- Q&A: Dimensions Of Valterra RV Waste Valve
- Q&A: Replacement RV Waste Valve for 1-1/2 inch Valve
- Q&A: Recommended Hitch for a 1997 Ford Mustang GT w/ Dual Exhaust
- Q&A: Replacement Trailer Taillights for Peterson PM147
- Article: Most Popular Wheel Bearings
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)