Recommended Switch That Has Two Inputs and a Single Output
Updated 01/22/2024 | Published 01/19/2024
Products Featured in This Question
Question:
Can i use this diode to have 2 inputs for one light? ie have one input be powered by an auxilary switch and the 2nd input be powered by fog light wiring? Would it be safe if both inputs were powered at once? And would the light remain on?
asked by: Thomas S
Expert Reply:
No, the purpose of the Roadmaster Hy-Power Diodes # RM-792 is to allow electrical current to flow in only one direction - from the motorhome to the car - preventing electrical feedback.
Your best bet is to use a single pole dual throw switch # 37213095 which can select any one of the two inputs to the output depending upon the position of the switch.
Product Page this Question was Asked From
Roadmaster Hy-Power Diodes (Qty 2)
- Accessories and Parts
- Flat Tow Wiring Harness
- Diodes
- Roadmaster
more information >
Continue Researching
- Q&A: Parts Needed to Flat Tow 2024 Chevrolet Silverado 1500 Trail Boss
- Q&A: Which Folding Handrail Is the Strongest? A Stainless Steel or Aluminum One?
- Q&A: Troubleshooting Installing Tow Bar Wiring On a Vehicle w/ Separate Brake Signal And Turn Signals
- Q&A: Parts Needed For Flat Towing A 2012 Honda CR-V
- Q&A: Need Fridge Similar To Everchill RV Refrigerator WAY44FR But Different Brand
- Q&A: SeeLevel II Bluetooth Monitor Kit with 2 Sensor Strips
- Q&A: Diode Recommendation to Prevent Trailer Battery From Backfeeding onto Vehicle Wiring
- Article: How to Choose a High-Low Adapter
- Article: Diode Installation Instructions for Dinghy with Combined Tail Light Wiring
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Flat Towing Package for 2015-2018 Ford F-150
- Article: Trailer Wiring Diagrams
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring