Can the Dexter BrakeRite Be Used With Drum Brakes

Question

Question:

Can this unit be used with drum brakes ? Is there a way to adjust the pressure down for that?

asked by: Robert G

0

Expert Reply:

Yes, the Dexter BrakeRite Electric Over Hydraulic Actuator for Disc Brakes # DX82KR can be used with drum brakes when it's used with the Drum Brake Reducer, but unfortunately the pressure can't be adjusted.

expert reply by: Bryce D

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 3

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 6

I have to go off the GM dealership recommendation. If they are saying you need the Hydrastar #HBA-CAM or Dexter #DX35FR adapter module for your factory brake controller to work with your electric over hydraulic brake actuator, then I can't really…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

You did your research extremely well Todd. The parts you listed are exactly what you need to do a disc brake conversion on your 2024 Brinkley Model Z 5th Wheel Trailer. You'll need two sets of the DeeMaxx Disc Brakes - 13" Hub/Rotor item…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Al, I have a solution for you but we don't have anything that is a direct replacement for the Kodiak 204 caliper including the DeeMax you referenced. . Since Kodiak was bought out by Dexter it seems they discontinued the 204 caliper in favor…

view full answer...

Can the Dexter BrakeRite Be Used With Drum Brakes

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching