Recommended Roof Rack for a 2024 GMC Savanna Van

Question

Question:

Can you provide me with a list of parts to add a roof rack to a 2024 GMC Savanna work van?

asked by: Michael M

0

Expert Reply:

I would be happy to! To add a roof rack to your 2024 GMC Savanna Van you will need the following parts:

Rhino-Rack Vortex Aero Crossbars - Aluminum - Black - 65" Long - Qty 2 item # RRVA165B-2

Rhino-Rack Roof Rack Legs - Gutter Mount - 5-15/16" Tall - Qty 4 item # RRRL150GMC-2

RLTP Leg Adapters for Rhino-Rack Vortex Aero Crossbars - Track Mount - Qty 4 item # RRVA-FK1-2

This aero bar roof rack system has a 165 lbs capacity. It has included locks to help prevent theft. The rubberized vortex strips in the top channels dramatically reduce drag and wind noise.

expert reply by: Jerred H

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Hey Daniel congrats on the new truck! The Lomax Stance Hard Tonneau Cover item #LOM54RV does indeed fit the 2026 Chevrolet Silverado EV with the Mid Gate. It also works with the Multi-Flex Tailgate that comes on the Trail Boss models. For a…

view full answer...

Answer 9

Hello John, thanks for reaching out. Yes, we do have a Thule roof rack that will allow you to install the Hullavator #TH898 on your 2015 Subaru Forester. For that I recommend the following: - Thule WingBar Evo Roof Rack for Raised Rails - Aluminum -…

view full answer...

Answer 10

Hey Craig, thanks for reaching out! I believe the Optronics Fleet LED Trailer Tail Lights w/ Grommets #TLL12RK will work as replacements for your 2008 Featherlite 4926 trailer, but you'll need to confirm this on your end. These lights carry the…

view full answer...

Recommended Roof Rack for a 2024 GMC Savanna Van

Products Featured in This Question

Continue Researching