Do you Offer Replacement Parts For RVLOVENT 12 Volt Roof Vent Fan?

Question

Question:

Hi, Im looking for a lift arm that works with RVLOVENT 12V RV Roof Fan Vent 14 3 Speed? Do you have any? Cheers

asked by: Dan B

0

Expert Reply:

I recommend considering replacing your roof vent as it appears the RVLOVENT does not offer any replacement parts. I recommend looking at the MaxxFan Plus Roof Vent # MA00-04500K which would also be a nice upgrade. The vent has a 10 speed fan with power lift, and a wireless remote for easy controllability.

expert reply by: Bud M

0

Answer 1

Hey Jeff! So in order to find the correct replacement power center for your trailer, you'll just need to know the amp rating of the charge converter. So for instance, the Progressive Dynamics 4000 Series RV Converter w/ Charge Wizard and AC/DC…

view full answer...

Answer 2

Like you mentioned, the replacement boards have been discontinued, so really the only option we can offer is a new water heater. I fully realize it's not what you are wanting to hear, but it's the best we can do to get you a working water…

view full answer...

Answer 3

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point Calibration The…

view full answer...

Answer 4

The brown wire from the operating unit on the Demco SBS Stay-IN-Play DUO Supplemental Braking System #SM99251 will splice to the orange wire from the breakaway switch and then continue on through the 20 Amp fuse up to the 12V positive post on your…

view full answer...

Answer 5

Hey Mayra, thanks for the information and the picture. The Replacement #921 Lamp Bulb item #VA0415-00 would indeed replace your Hengs Range Hood Model RO624500C lamp. However, I have a better option for you. I recommend the 921/906 LED Light Bulb…

view full answer...

Answer 6

Hey Paul! The PullRite SuperGlide #PUL43RR (2714) and #PUL73RR (2914) do weigh the same. The main difference is the capacity, which is going to come from the base of the 5th wheel hitch. Since your 2027 Keystone Cougar 316RLS has a GVWR of 12,900 lbs…

view full answer...

Answer 7

Hey Bruce! Thanks for providing your serial number. That is a 1621 so the Curt Helux will not fit. Those are only designed to fit the Rhino bolt pattern. For a comparable replacement I recommend the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box…

view full answer...

Answer 8

Yes you are correct the Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid #MA00-04751KSX is the right replacement and measures 18 1/8" long and 16 1/2" wide, which is the same measurements as your current MaxxFan Plus Roof Vent w/…

view full answer...

Answer 9

Hi Shawn! The Champion 4,000-Watt Portable Inverter Generator - Gas - Manual Start - CO Shield - RV Ready #CH79FR can indeed be used 6 to 10,000 feet up, but it should be noted that engine power and generator output will be reduced approximately 3.5%…

view full answer...

Answer 10

Hello again Thomas! The #MA00-04751KSX does indeed need to be a wired to a wall control for it to work. It's really used as a replacement or upgrade to a pre-existing damaged or worn out unit. I believe what you are looking for is the MaxxFan…

view full answer...

Answer 11

Hey Paul, yes we do. You can use the Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid #MA00-04751KSX to replace your current fan and will work with your original controller and garnish.

view full answer...

Do you Offer Replacement Parts For RVLOVENT 12 Volt Roof Vent Fan?

Product Page this Question was Asked From

Continue Researching