TecNiq Industrial LED Scene Light Mounting Hole Spacing

Question

Question:

What is the distance from mounting hole to mounting hole?

asked by: Terry C

0

Expert Reply:

The TecNiq Industrial LED Scene Light # TN43XR has 3/16" diameter mounting holes spaced 16" apart on center (see attached).

expert reply by: Jon G

0

TecNiq Industrial LED Scene Light Mounting Hole Spacing
(click to enlarge)

Answer 1

Hello Jimmie, thanks for reaching out. For the TecNiq Industrial LED Scene Light #TN43XR the white/red wire is for power and the black is ground.

view full answer...

Answer 2

Hey Brad! The TecNiq Industrial LED Scene Light #TN43XR is water resistant and has the TecNiq TecSeal meaning it is outdoor certified. I wouldn't recommend submerging them (shouldn't be a problem for a cargo trailer I hope) but exposure to…

view full answer...

Answer 3

Hey Greg, I drew up a little diagram showing the hole spacing for the TecNiq Industrial LED Scene Light #TN43XR. If you need any other measurements let me know and I'd be happy to help.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

TecNiq Industrial LED Scene Light Mounting Hole Spacing

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching