Size of Lionshead Trailer Wheel Swivel Flange Lug Nut

Question

Question:

I see where the stud that it fits is a 5/8” but I can’t seem to find anywhere that states the nut/socket size. So what is the Nut size?

asked by: Monte L

0

Expert Reply:

In this case, the size of the wheel stud it fits and the size of the nut are interchangeable for size; the Lionshead Trailer Wheel Swivel Flange Lug Nut # LI84FR is a 5/8"-18 nut.

expert reply by: Kyle S

0

Answer 1

The Westlake 215/75R17.5 Radial Tire w 17-1/2" Lynx Aluminum Wheel #LHAS701 are intended for wheel bolt size 9/16-18 with an 8 on 6-1/2 inch bolt pattern. These wheels with that bolt pattern and wheel bolt size are rated for 4,805 lbs at 123…

view full answer...

Answer 2

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 3

Dexter Flange Wheel Nut #95188 is sold individually so you will need to order the specific quantity you want when placing your order. The nut has an inside diameter of 5/8-inches,18 threads per inch and it is shown in the linked photo.

view full answer...

Answer 4

I went out to the warehouse with a handful of sockets to see which size fits over Flange Wheel Nut - 5/8" Item #95188. It takes a 1-1/8 inch socket. I have linked a video review of this nut for you.

view full answer...

Answer 5

For the Dexter 10K axles a 5/8" wheel nut #95188.

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Size of Lionshead Trailer Wheel Swivel Flange Lug Nut

Product Page this Question was Asked From

Continue Researching