Are Instructions for Pairing Pace Edwards Bedlocker Remote Same if Only One Remote

Published 09/06/2023

Question:

What if you only have one key fob to program for the bedrocker bed cover when you go to program the remote

asked by: Amber

Expert Reply:

The instructions for programming the Bedlocker Remote part # PE33QJ are the same for a single remote or if there's two.

1. Disconnect the power to the Bedlocker unit. (This can either be done at the battery or at the canister where the wires come out)

2. Reconnect the power and immediately push the open button on both remote key fobs.

3. Wait 15 seconds after pushing the buttons and try to operate the unit. (It should operate normally at this time)
The Electornics box goes into program mode for 2-3 seconds once power is reconnected. If power is lost to your
truck and the buttons are not programmed within 3 seconds of power being restored everything should stay as it
was. If you find this not to be the case please try reprogramming it as above.

expert reply by: Jameson C