Will New Reese Spring Bars Fit in Place of Older Draw-Tite Spring Bars
Updated 03/12/2014 | Published 03/11/2014
Products Featured in This Question
Question:
Will these work on draw tite weight distribution systems? they look identical to the draw tite bars i have.
asked by: Dave
Expert Reply:
If your bars are labeled as Draw-Tite then the system is probably fairly old. There have been changes made to the heads over the years and the new bars will not fit in the old head. To change the bars you would also need to change the head with # RP58167.
If you can tell me the approximate age of your weight distribution system I can determine if you can use the new bars or would have to also replace the head.
Product Page this Question was Asked From
Replacement Trunnion Spring Bar for Reese Weight Distribution System - 800 lbs TW
- Accessories and Parts
- Weight Distribution Hitch
- Spring Bars
- 800 lbs TW
- Trunnion Bar
- Reese
more information >
Continue Researching
- Q&A: What Head and Ball do I Need for My Reese Trunnion Bars with 22210E Stamped on Them?
- Q&A: Replacement Shroud For Coleman-Mach AC 8333-8664
- Q&A: Replacement Reese Weight Distribution Head for Bars Stamped 22210
- Q&A: Installation Instructions for Reese Strait-Line Weight Distribution Systems
- Article: Trailer Wiring Diagrams
- Q&A: Correct Spring Bars for Reese WDH for 6,000-7,000 Pound Trailer
- Q&A: Replacement Door for an Atwood GE16EXT Water Heater
- Q&A: How to Mount 2 Batteries on A-Frame Trailer with Limited Space on Tongue
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Charge a Dump Trailer Battery
- Article: Happy Holidays from etrailer!
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?