Distance From Front And Back Holes To The Edge Of The Receiver On The Draw Tite 75210
Updated 07/24/2023 | Published 07/21/2023
Question:
What is the horizontal distance from the first hole to the end of the receiver like you provided for the Curt hitch?
asked by: Jason
0
Expert Reply:
I grabbed a tape measure and went out to our warehouse to measure the Draw Tite hitch # 75210. From the center of the first hole to the edge of the receiver measured 9-3/4". From the second set of holes it is 12-1/2" to the edge of the receiver. I made a drawing for you which I have included below.
expert reply by:
Jesse M
0
75210 drawing
(click to enlarge)
(click to enlarge)
Continue Researching
- Shop: PTC Custom Fit Cabin Air Filter - Charcoal
- Shop: etrailer Bucket Seat Protector for Active Lifestyle - Waterproof - Easy On/Off
- Shop: Yakima FullSwing Bike Rack for 4 Bikes - 2" Hitches - Swing Away
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Yakima LongHaul RV Bike Rack - 4 Bikes - 2" Hitches - Silver
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Shop: Air Filter
- Shop: Trailer Wiring
- Shop: Vehicle Lights
- Shop: Performance Chip Tuners
- Shop: Base Plate for Tow Bar
- Shop: Side Window Vents
- Q&A: Will The Draw Tite 75210 Fit Vehicles With The Factory Step Bumper
- Q&A: Trailer Hitch for 2004 Freightliner Sprinter 2500 with Factory Step Bumper
- Q&A: Trailer Hitch for 2006 Dodge Sprinter That Fits Around Spare Tire
- Q&A: Hitch and Wiring Fits for 2004 Dodge Sprinter
- Q&A: Exact Measurements for Curt and Draw-Tite Hitch Receivers for a 2005 Dodge Sprinter
- Q&A: Compatibility Of Swing Away Hitch Bike Rack With Cargo Basket That Has Extender
- Q&A: Swing Away Bike Rack that Fits 2008 Dodge Sprinter that Allows Rear Door Access