Which Grease Seal is Associated with L68149 Bearing and L68110 Race on a Boat Trailer Hub  

Yes. The Replacement Non-Slip Adhesive Safety Strip, 6" x 18" #NSWS is one step tread. If you are looking for another option, I've linked the page to all of our Grip Tape options to assist.

When you have cupping wear on a tire it is from the tire bouncing on the road. You will want to check the air pressure in the tire and make sure you are running the maximum air pressure that is indicated on the tire. Then, I would recommend to have…

I consulted with our resident tire expert, and we're both at a loss. Heat build-up caused by over or under inflation, overloading the tire or failing to observe the speed rating of the tire (65mph in most cases) are the typical causes of…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

It is not recommend to jack up a trailer by the axle. This may cause damage to the axle itself. It also puts too much stress on the leaf springs. Instead, you will want to place the jack under part of the trailer frame preferably next to the leaf…

The Dico 15638 is a 10 x 2-1/4 inch brake drum/hub that used kind of an oddball bearing setup, inner bearing LM67048 and 3/4 outer bearing LM11949. None of the hub/drums we currently carry are compatible with this bearing set. If the drums are still…

The difference is the material the Bearing Buddy is made from. The part #BB2047SS is made from stainless steel and the #BB2047 is chrome plated steel. Stainless will hold up to corrosion much better.

You can equip your pontoon boat trailer with either hydraulic drum or hydraulic disc brakes. You are correct that electric brakes are not a good option since water and electricity don't get along well together. You can get a start by reviewing…

I spoke with my contact at Carlisle who manufacturers Hydrastar about your 2014 Ford F-150 with the factory brake controller. In order for the brakes to operate correctly with the Hydrastar actuator, you will need the Carlisle Control Adapter Module,…

HydraStar Marine Electric Over Hydraulic Actuator w/ Breakaway and 7-Way RV Harness - 1,200 psi Item #HS381-9066 will work with the GM factory brake controller if used with adapter #HBA-CAM. If the adapter is not used then you would have to have an…

The L68110 race, which is very common to boat trailers, is available individually and is compatible with the L68149 bearing. Although the outer diameter of the two races is pretty close (2.362 for the L68111 versus 2.327 for the L68110), I would…

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…