Determining Where Receiver Tube End Will Be On 1995 Ford F-350 With CM Flatbed Conversion

Updated 07/11/2023 | Published 07/10/2023

Question:

I’ve got a 1995 ford f350 dually that had a dually bed on it but was converted to a CM flatbed before I bought it. I’m needing a bumper pull hitch that will fit it and stick out past or even with the flatbed.frame width is 37-1/2 inches. Do you sell anything that would fit that? Thanks

asked by: Austin H

Expert Reply:

To verify exactly where the end of the B&W Heavy-Duty Trailer Hitch Receiver # BWHDRH25122 will sit in relation to your CM flatbed you will need to measure from the mounting holes. The rearmost mounting hole which will sit just behind the rivet in the rear of the frame is 12" on center from the end of the receiver. I have linked the installation instructions below as well as included an image with the dimensions for the receiver.

expert reply by: Bud M