Is a Dust Cover for the Winch End On a Bulldog Winch Available?

Question

Question:

RE: BDW20207...I know this comes with dust cover on the truck end but is there a dust cover I can get for the winch end ? and if so which one..I see you have 3 different ones on your website. Thank you

asked by: Michael C

0

Expert Reply:

There is only one dust cover offered with the Bulldog Winch Quick-Connect Set for Powersports w/Dust Cover # BDW20047 is because the end where you'd use the included dust cover would also be connected to the battery and if water got in it could cause corrosion.

The other end would not have any power going to it and would not need a cover since corrosion wouldn't be possible. You could put dielectric grease # 11755 to protect your pins but other than that there isn't an option since a cover is not offered.

expert reply by: Bryce D

0

Answer 1

Sounds like you are looking for standard winch quick connect connectors part #BDW20047 which are what are normally used to make wiring connections to winches.

view full answer...

Answer 2

The Bulldog Winch quick connectors #BDW20047 themselves do not have any sort of cover to protect them from the elements. But what you could do is modify mounting box #RP74641 and that will help protect them. There is no one place that you have to…

view full answer...

Answer 3

I have a solution for you to maintain your trailer's battery while towing, but we do not offer an aux socket adapter for your battery charger from Schumacher. There is not a great way to charge your trailer's battery while towing, but you can…

view full answer...

Answer 4

I did some searching around on the internet and came up with a few interesting tips to prevent rodents from eating vehicle/trailer wiring. Here is what I found: Noise will keep the rodent's away. So a portable radio would work for this. Flashing…

view full answer...

Answer 5

The Bulldog Winch Quick-Connect Set part #BDW20047 only comes with one cover/plug. The reason for this is because the side attached to the battery would still be live which is the side you would use the plug on as water could get into the connector…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Is a Dust Cover for the Winch End On a Bulldog Winch Available?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching