Cover for 4-Way Trailer Wiring Connector

Question

Question:

i am looking for a rubber cap to snap over my 4 prong wiring harness, do you have it or were can i find one , thank you

asked by: Gary Z

0

Expert Reply:

Sounds like you are looking for the Curt 4-Way Flat Wiring Connector Cover # C58200 which is a universal style 4-way dust cover that can be closed when not in use to protect the connector.

expert reply by: Jameson C

0

Answer 1

We do have replacement covers for 4-way connectors with the part #C58200.

view full answer...

Answer 2

The Wesbar license plate bracket part number 003201 that you referenced is a universal license plate bracket just like the Optronics Trailer License Plate Bracket part #LP15SB. To see if the mounting holes would line up check out the dimension…

view full answer...

Answer 3

If you had single wire trailer taillights initially that meant that the assemblies grounded through the mounting hardware. If you went to a two wire light that would mean you would actually have to ground each of the assemblies using the white wire…

view full answer...

Answer 4

Instead of cutting off your plug and splicing, I recommend using the Hopkins 4-Pole Loop - 12" Long #HM48145 along with some dielectric grease like the Loctite Bulb, Lamp, and Electrical Connection Dielectric Grease - 0.33-Oz Tube #LT37534 to…

view full answer...

Answer 5

In order to find a replacement side marker light for your 2015 Dynamax Dynaquest I recommend taking some measurements of the current light. There is not a direct replacement available so you will need to find something that is a close match and…

view full answer...

Answer 6

For a cover designed to fit over standard 4-way connectors we have the #C58200. Another very helpful idea will be to put dielectic grease on the pins of your 4-way. This will actually be your best way to fight the corrosion. For that you would want…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 12

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Cover for 4-Way Trailer Wiring Connector

Product Page this Question was Asked From

Continue Researching