Removing Rust from Metal Trailer Fenders For Paint Prep
Updated 06/20/2023 | Published 06/19/2023
Question:
I did not paint when install now as little surface rust whats best way to prep to paint stop the rust
asked by: John R
Expert Reply:
The trailer fender part # HP36VR that you referenced is raw steel so it's going to rust if it's exposed to moisture. When you go to paint yours I would take some steel wool to the rusty areas to get it all off and then prime and paint it whatever color you like and you'll be good! You might even see if you can find a spray paint that has a primer in it already to eliminate that step. Most paints are good to use on metal surfaces too so it shouldn't be super hard to find what you would need.
Product Page this Question was Asked From
Single Axle Trailer Fender w/ Backing Plate - Steel - 14" to 15" Wheels - Qty 1
- Trailer Fenders
- No Step
- 14 Inch Wheels
- 15 Inch Wheels
- 9 Inch Wide
- 32 Inch Long
- Steel
- Bolt-On
- Weld-On
- For Single-Axle Trailers
- etrailer
more information >
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Can etrailer Single Axle Trailer Fender w/ Backing Plate Be Installed Via the Backing Plate
- Q&A: What Size Tires Fit 15x6 Inch Steel Trailer Wheels
- Q&A: Determining Which Trailer Fender Size is Needed
- Q&A: Enclosed Trailer Door Latch Rattles, What Tight Options To Replace It With?
- Q&A: Looking For Caliper To Replace Discontinued Tie Down Engineering 46802 Caliper
- Article: Trailer Wiring Diagrams
- Q&A: How To Measure a Boat Trailer Fender Without Removing the Wheel
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Lighting Requirements