Recommended Transfer Switch For A 1999 Winnebago Adventurer 33B Class A Motorhome

Question

Question:

which transfer switch would I want for a 99 winn adventurer 33 b. Your help is greatly appreciated..

asked by: Glenn W

0

Expert Reply:

Since you have a 1999 Winnebago Adventurer 33B Class A Motorhome you would most likely have 50 amp service and would need a 50 amp transfer switch like the Progressive Dynamics 50A Transfer Switch # PD52. I have attached a short video below where Dave will walk you through the installation process and show you this switch in use.

expert reply by: Kevin C

0

Answer 1

Each inverter is going to have a very specific way to wire it into your trailer's electrical system in order to prevent the power loop you're referring to. In some cases where an inverter doesn't come with a transfer switch and requires…

view full answer...

Answer 2

Yes, the Progressive Dynamics Transfer Switch part #PD5110010Q can be run continuous while hooked up to a generator so long as the switches rating is not exceeded.

view full answer...

Answer 3

If the contacts on your relay are burned or pitted (see photo) then that means its voltage is dropping below 90 VAC under load. If this problem has occurred then you will need to replace the entire unit, Progressive Dynamics Transfer Switch part…

view full answer...

Answer 4

Hey Ana! That picture doesn't look like much fun, hopefully the only thing that got damaged here was your transfer switch. The 2005 Ford Miranda Motorhome #PD5110010Q will work as a replacement for your motorhome since it is also 30A. Also yes,…

view full answer...

Answer 5

Hey Bruce, it sounds like there could be a number of things going on. I'd suggest starting by checking the wiring first and make sure that everything is connected correctly and nothing is loose. I'd also recommend checking your ground…

view full answer...

Answer 6

I have a solution for you but you can not connect an inverter directly to the AC input of the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger 35 Amp item #PD4135K. You will need to use the Progressive…

view full answer...

Answer 7

Hey William, thanks for reaching out! The PD5110610 was discontinued and replaced with the Transfer Switch w/ Quick Flip Connectors #PD5110010Q so this is the part you'll want to use as a replacement.

view full answer...

Answer 8

You'll simply slide the bare end of the wire into the quick connect and flip the orange lever down to lock the wire in place. The wiring diagram for the Progressive Dynamics Transfer Switch with Quick Flip Connectors - Plastic Case - 30 Amp -…

view full answer...

Answer 9

Hello Sam, thanks for getting in touch, and for your recent order. The #PD5110010Q transfer switch can be mounted vertically or horizontally. As long as it is securely mounted to a flat surface where it won't move around during travel you will be…

view full answer...

Answer 10

From what I can see the PowerTek-PDC 1009 has a converter rated for 30amps so the Progressive Dynamics #PD4045KA would be the closest replacement, but you'll need to increase the wire gauge running from the battery to the converter. You can still…

view full answer...

Answer 11

The Progressive Dynamics 5100 Series Transfer Switch, #PD5110010Q that you linked to will automatically reroute your RV's AC input from shore power to generator power when activated. While many manufacturers will source parts from the same…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Recommended Transfer Switch For A 1999 Winnebago Adventurer 33B Class A Motorhome

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching