Measurement of 3,500 lb Kodiak Disc Brake Caliper from Brake Mounting Flange
Updated 05/18/2023 | Published 05/17/2023
Question:
How much clearance do i need between the brake flange and the trailer frame? Or, from the brake flange, how far inboard do the caliper and slider pin extend? Ive got maybe 3 inches and tie down g5s fit no problem. the problem is, well, theyre tie downs. Thanks
asked by: Bil
Expert Reply:
I went out to the warehouse and measured the Kodiak Disc Brake Kit # K2R35DKG and found that the back head of the bolt (the farthest part out) sits about 2-1/2" away from where the brake mounting flange will install so it looks like you'll have about 1/2" of space to work with.
(click to enlarge)
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 10" Rotor - 5 on 4-1/2 - Dacromet and KodaGuard - 3,500 lbs
- Trailer Brakes
- Disc Brakes
- Marine Grade
- 5 on 4-1/2 Inch
- Rotor
- 3500 lbs Axle
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Kodiak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Surge Brakes for Demco KK260 Tow Dolly
- Q&A: Will The Kodiak Disc Brake Kit K2R35DKG Fit The etrailer Hub AKIHUB-545-35-G-K?
- Q&A: Replacement Brake Setup for Trailer with DB-42 Disc Brakes
- Q&A: What is the Difference Between the Kodiak Disk Brake Kits K2R35DKG and K2R35DS?
- Q&A: Correct Mounting Bracket Bolts for Kodiak Disc Brake Kit
- Q&A: Recommended Disc Brake Hubs, Lines, and Hydraulic Actuator for a Boat Trailer w/a 3,500 lbs Axle
- Q&A: Looking To Replace Tie Down Engineering Brake Pads And Rotors
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Trailer Couplers
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: Adding Electric Over Hydraulic Disc Brakes