Flexible Brake Line Compatible With Demco Brake Line Kit For Using With Swing Away Trailer Tongue
Updated 05/12/2023 | Published 05/10/2023 >
Products Featured in This Question
Question:
Im considering this kit to replace the brake lines on my boat trailer. Currently a metal line runs from the actuator to a flexible rubber line, then transitions back to a metal line out to the axle. I have a swing away tongue, so would need an additional flex rubber line to connect to the two metal lines small existing line from actuator and new long metal line back to axles. Would this kit work with an additional rubber/flex hose, if so which one would work? Thanks
asked by: Drew B
Expert Reply:
You will be able to pair the Demco Hydraulic Brake Line Kit # DM5424 with the 25" Line # T0980100. This will allow for you to use your swing away tongue operate. A Bracket # DM05981-95 will secure the end near your swing away to prevent the hard line from moving around and rubbing on the front of the trailer.
Product Page this Question was Asked From
Demco Hydraulic Brake Line Kit for Single Torsion Axle Trailers - Drum or Disc Brakes
- Accessories and Parts
- Brake Actuator
- Trailer Brakes
- Disc Brakes
- Hydraulic Drum Brakes
- 15 Feet Long
- Brake Lines
- Steel Line and Flexible Hose
- Brake Line Kits
- Single Axle
- Demco
more information >
Continue Researching
- Video: In-Depth Review of the Dexter Hydraulic Brake Line with Fittings
- Shop: DeeMaxx Hydraulic Brake Line - Rubber - 3/16" Brass Male Inverted Flares - 1-1/2' Long
- Shop: Demco Hydraulic Brake Hose with Fittings - 19" Long
- Shop: Demco Flexible Brake Hose - Solid Male and Solid Female Fittings - 12" Long
- Shop: Clip for Dexter Flexible Brake Line Tubing
- Shop: Dexter Hydraulic Brake Line with Fittings - 25" Long
- Shop: Dexter DX7.5L A-60L Surge Brake Actuator with Fill Cap - Drum - 2" Ball - Primed - 7.5K
- Shop: Dexter Premier Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Article: Most Popular Wheel Bearings
- Q&A: Trailer Brake Recommendations for a Boat Trailer
- Q&A: Should the Grease Bolts Be Tight on the Dexter DX7.5 Drop-N-Go Brake Actuator?
- Q&A: Replacement Inner Member for a Dexter Model A60/A75/XR84 Brake Actuator
- Q&A: Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Brake Assembly Needed For A Trailer With Timken 2788 And 1779 Bearings
- Q&A: Replacement Caliper Mounting Bracket for a CMB-10-UA Over the Hub and/or Stainless Steel Bracket
- Q&A: Availability Of 5 On 4-1/4 Hubs And How To Measure A 5 Or 6 Lug Pattern
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: 7 Common Questions Everyone Has About Trailer Tires

