SumoSprings Kit for Front and Rear of 2011 Itasca Cambria Ford E-450 Chassis
Updated 04/26/2023 | Published 04/25/2023
Products Featured in This Question
Question:
I have a 2011 30 RV Itasca Cambria Ford E-450 Gas V-10 2WD. I want to change out the old bump-stops for some sumo springs front and rear. Please supply product number. Thanks so much.
asked by: David H
1
Helpful Expert Reply:
For your 2011 Itasca Cambria built on a Ford E-450 chassis the correct front SumoSpring kit would be the part # SSF-106-47 and then for the rear part # SSR-107-54 and you'd be set.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
SumoSprings Solo Custom Helper Springs - Front Axle
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Light Duty
- Front Axle Suspension Enhancement
- SuperSprings Intl
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Best Sumo Springs For 2022 Nexus Viper V25/ Ford E450
- Q&A: Difference Between The SumoSprings Helper Springs # SSR-106-54-1 And # SSF-106-47
- Q&A: When Flat Towing a Vehicle How Much Tongue Weight is on the Trailer Hitch
- Q&A: Tow Bar And Base Plate For A 2024 Jeep Wrangler Unlimited Rubicon
- Q&A: Best Suspension Enhancement & Steering Stabilizer For 2023 Jayco Greyhawk 27U
- Q&A: Can SumoSprings Maxim Kit Install on 2024 Entegra Esteem
- Article: Stability Control for Heavy Duty Vehicles
- Q&A: What SumoSprings Will Fit a 2022 Jayco Greyhawk E-450 Chassis With J-Ride Factory Suspension?
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Performance Chips and Modules
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Flat Towing Package for 2010-2013 Chevrolet Equinox