Will The Keel Pads Mount To 2x4 Bunk Boards On a Boat Trailer?
Published 04/22/2023
Products Featured in This Question
Question:
Can I use them on a 2x4 on bunks.
asked by: Terry M
Expert Reply:
The Yates Keel Pad # YR1203SB is designed to fit on 3" wide frames and crossmembers. To mount them on bunk boards you would have to notch the 2"x4" for them to even fit. Also the pad is not designed to hold the boat like you get with Bunk Board Carpeting # CE11330. They are designed to let the boat easily slide if it were to accidently hit that portion of your trailer and are not rated to hold the weight of the boat all the time.
If you are looking for something to make launching and retrieving your boat easier you should consider Roller Bunks # DL21741.
Product Page this Question was Asked From
Yates Keel Pad - TPR - 11-3/4" Long x 3-1/2" Wide - Blue
- Boat Trailer Parts
- Guards and Pads
- Keel Pad
- 3-1/2 Inch Wide
- 11-3/4 Inch Long
- Yates Rubber
more information >
Continue Researching
- Q&A: Looking For Guide Posts With Trailer Tail Lights That Go On Top
- Q&A: How to Install Yates Keel Pad on Crossmember
- Article: Best Boat Trailer Jacks
- Q&A: Do You Have a Bearing Buddy Bra w/a 2-1/8" Diameter?
- Q&A: Keel Pads For Crossmember On a ShoreLander Boat Trailer
- Q&A: Can Different Grease Seals be Installed on Dexter Hubs 8-213-5UC1-EZ to Make Them Fit 2.25" ID?
- Q&A: How to Install the Yates Keel Pads on Your Trailer
- Q&A: Recommended Leaf Springs for 4,400 lb Axle Based on Axle Position and Hanger Locations
- Article: Trailer Tire Sizing
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: The Best Boat Bumpers
- Article: How to Measure for Trailer Hitch Drop