Measurements of Mounting Flange Slots on Ultimate Trailer Jack # 322-RDJ-2K
Updated 02/22/2023 | Published 02/20/2023
Question:
What are the measurements of the mounting flange slots from the adjuster ring
asked by: Richard C
0
Expert Reply:
The slots on the Ultimate Trailer Jack # 322-RDJ-2K from the inside of the mount near the jack tube are 1/8" from the inside. The slot itself is 7/8" long putting the outer edge 1" from the jack tube. The outer tube diameter is 2-1/4" for your center mount cutout. The mounting holes should be between 3" and 3-1/4" on center to ensure this jack will fit on your trailer mounting bracket.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs
- Trailer Jack
- Utility Trailer
- A-Frame Jacks
- Topwind Jack
- 1001 - 2000 lbs
- Manual Jack
- 28 Inch Lift
- Bolt-On
- Weld-On
- With Rectangle Foot
- Ultimate Jack
more information >
Continue Researching
- Q&A: Lowest-Profile A-Frame Trailer Jack For Tailgate Clearance
- Q&A: Can I Install the Square A-Frame Jack w/ Footplate e74VV in a Round A-Frame Hole?
- Q&A: How To Stop A-Frame Jack From Scrapping Ground While Going Over Bumps
- Q&A: Low Profile Trailer Jack Recommendation for Better Tailgate Clearance
- Q&A: Adjustment Pin Location on 2K Ultimate Trailer Jack
- Q&A: Looking For Replacement Pins For etrailer Adjustable Ball Mount e66PR
- Article: Holiday 2025 | Best Gifts for Towers
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Jacks
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: How to Measure Your Trailer Wheel Bolt Pattern