Replacement Hardware For Trailer Hitch On A 2004 Ford Explorer Sport Trac

Question

Question:

Looking to buy the hardware to install your draw tight max for a 2004 Ford Sport Trac. It was on my truck when I bought it, but they had removed it and said they cut it off and ruined the bolts to install. Would like to have you help me with the right kit. I am 70 and having trouble finding the correct kit. Thank you.

asked by: Frankie L

0

Answer 1

Yes, the Curt Class III Hitch, part #13407, will fit your 2003 Ford Explorer Sport Trac without removing the factory size spare tire. Spare tires larger than the factory size are not tested with trailer hitches so if your spare is larger than OEM it…

view full answer...

Answer 2

The full-size spare tire on your 2002 Ford Explorer 4-Door 4WD will remain accessible after you install Draw-Tite Class III hitch #75132. I confirmed this with my technical contact at Draw-Tite. I have linked for you the written install instructions…

view full answer...

Answer 3

Hey Ed, I wish we carried a solution that would work for you but at this time we do not have any hitches that fit your 2004 Ford Explorer as everything we carry is designed to fit below an installed OEM hitch. Since yours is gone you'd want to…

view full answer...

Answer 4

All three of the 2-inch Class III hitches we offer for your 2004 Ford Explorer can be seen on the linked page and all three are as you noted intended for use along with the OEM 1-1/4-inch Class II hitch that came on the vehicle from the factory. We…

view full answer...

Answer 5

Yes! Both the Curt #C13550 and Draw-Tite #75132 trailer hitch options are designed to installed directly under the 1-1/4" receiver currently on your 2005 Ford Explorer. The installation for either one will actually be pretty easy as they have…

view full answer...

Answer 6

I looked through the owner's manual for your 2001 Explorer Sport Trac and found nothing stating that the vehicle couldn't be used for towing, although the capacity varies according to the engine and transmission used on your vehicle. Consult…

view full answer...

Answer 7

Hey Tina, for your 2005 Ford Explorer Sport Trac you can use the Draw-Tite Max-Frame Trailer Hitch Receiver #75112. This hitch has a max weight capacity of 6,000 lbs, a 600 lb tongue weight capacity, and is custom fit so it'll bolt right up.…

view full answer...

Answer 8

Good news! I was able to go out to our warehouse and measure the Curt Hitch #13407. I have attached an image to this page for your viewing convenience. The Curt #13407 is the confirmed fit for the 2004 Ford Explorer Sport Trac. This Curt Hitch #13407…

view full answer...

Answer 9

We do have a solution for a bike rack and cargo carrier; your best option would be to use the Yakima EXO Swing Away 2 Bike Rack w/ Enclosed Cargo Carrier - 2" Hitches #Y34ZR because this has a 40 lb per bike capacity and the carrier has a 100 lb…

view full answer...

Answer 10

It is not uncommon for some hitch installations to require spacer blocks of some kind to get the hitch to install properly. If they are required in your situation then it is permissible to use them. A spacer block such as #RP3022 could be used unless…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Replacement Hardware For Trailer Hitch On A 2004 Ford Explorer Sport Trac

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching