Replacement Cover Strip For Thule AeroBlade Crossbars

Question

Question:

I have Thule aero blades on my 2011 Mitsubishi outlander. The mounting straps had a rubberized cover that wore off. Do you guys sell replacement straps? I have photos to send once you respond.

asked by: Mike T

0

Expert Reply:

I believe you are referring to the top rubber cover of your Thule AeroBlade crossbars and for that we the Replacement Cover Strip with Pattern for Thule AeroBlade Edge Cross Bars - 59" Long # TH69JH.

These fit the 7501, 7501B, 7502, 7502B, 7503, 7503B, 7504, 7504B, 7601, 7601B, 7602, 7602B, 7603, 7603B, 7604, and 7604B crossbars.

expert reply by: Kyle S

0

Answer 1

No as they are different types of strips. The only replacement we offer is the Replacement Cover Strip with Pattern for Thule AeroBlade Edge Cross Bars - 59" Long #TH69JH.

view full answer...

Answer 2

Hello Jeff, Then correct replacement for your Thule Aeroblade (not the edge) is the Replacement Rubber Strip for Thule Aero Load Bars 53" #TH853354407. The Replacement Cover Strip with Pattern for Thule AeroBlade Edge Cross Bars - 59" Long…

view full answer...

Answer 3

Hey Joel, for your Thule Aeroblade crossbars the correct replacement top cover strip is the part #TH69JH that you referenced. Did yours fall off or did you misplace it?

view full answer...

Answer 4

Hi Jan! We do indeed have replacement cover strips for Thule WingBars. It does only come in 59" strips, so you will have excess that will need to be cut off, but you will want the Replacement Cover Strip with Pattern for Thule…

view full answer...

Answer 5

Hey Mark, thanks for the information. The European Thule WingBar is sold as the Thule AeroBlade in the US. This means you'll need the Replacement Cover Strip with Pattern for Thule AeroBlade Edge Cross Bars item #TH69JH. What do you use your roof…

view full answer...

Answer 6

I do not know if the Replacement Cover Strip with Pattern for Thule AeroBlade Edge Cross Bars - 59" Long #TH69JH will fit 2009 VW Golf factory crossbars, but I can tell you they are 3/4" wide so fit that size channel.

view full answer...

Answer 7

Scott, it looks like you are correct, Thule does make the crossbars for Volvo's. Really you can use any rubber strip to replace the missing one, you'd just need to know the channel width. For instance if you needed a 3/4" wide strip,…

view full answer...

Answer 8

The part number you mentioned is the Subaru/Thule Aeroblade crossbar so for a replacement rubber strip you would need the part #TH69JH.

view full answer...

Answer 9

If the Thule crossbar is the newer Wingbar you'd need the strip part #1500052989 or if it's the older Aeroblade you'd want the part #TH69JH.

view full answer...

Answer 10

The Replacement Cover Strip with Pattern for Thule AeroBlade Edge Cross Bars #TH69JH installs into the top t-slot, which does help to reduce wind noise. However, it sounds like you may have an OEM roof rack from Audi. I am not sure if this would be…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Replacement Cover Strip For Thule AeroBlade Crossbars

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching