Lippert Power Jack Won't Retract.

Question

Question:

Lippert model 1817941, hard wired to fully charged battery on Coleman trailer. Trying to hook up and switch will move jack up but not down. Help

asked by: David J

0

Expert Reply:

Since it won't retract you'll need to replace the switch with Replacement Extend/Retract Switch for Lippert Electric Trailer Jack # LC49MD.

expert reply by: Kyle S

0

Answer 1

Hey Gary, yes that does sound like a switch is at fault. I am not sure which Lippert jack you have but we do have the replacement switch part #LC49MD which does fit Lippert jacks. If what you have looks different email me a picture of the…

view full answer...

Answer 2

To replace the Extend/Retract Switch for Lippert Electric Trailer Jack #LC49MD you'll just need to keep track of how the original was hooked up and replicate that. Unfortunately Lippert doesn't have a wiring diagram but we do have a photo we…

view full answer...

Answer 3

Per the manufacturer when it comes to the shear pins being broken you would have to replace the whole Lippert Jack #LC298707 because the shear pins are not replaceable, and there is no way to fix them. What you will need to do is purchase a whole new…

view full answer...

Answer 4

Since the Lippert stabilizer jack motor can clearly work since it can extend but not retract that to me sounds like a bad switch which we offer with the part #LC144214.

view full answer...

Answer 5

If the Lippert Electric Trailer Jack #LC285318 will not retract then the first thing you will want to do is make sure there is power reaching the jack and it is properly grounded. If you use a circuit tester at the power wire just before it enters…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Lippert Power Jack Won't Retract.

Product Page this Question was Asked From

Continue Researching