Can The TST TPMS for RVs # TST-507-FT-4-C Ready A 0.1 % PSI

Question

Question:

How accurate are the sensors and will they ready .1 of a psi?

asked by: Don C

0

Expert Reply:

Yes, The TST TPMS for RVs # TST-507-FT-4-C can ready at 0.1 of psi. The pressure range of the system is 0 psi to 196 psi. The sensors are very accurate and will refresh automatically with new tire information every 5 minutes. The 4 flow through sensors will check the tire pressure and temperature every 12 seconds.

The sensors have an easy installation onto your tires' valve stems.

I attached a review video link below.

expert reply by: Noah E

0

Answer 1

The TireMinder i10 TPMS #TM38FR refreshes every 6 seconds. You will get a visual and audible alert when the monitor receives the signal from your tire sensor is either below your pressure or the temperature exceeds the maximum setting.

view full answer...

Answer 2

The typical tire should run about 158 degrees (Farenheidt) once you get going down the road, but this can vary greatly depending on the weight of the trailer, how fast you're traveling, and also driving habits. So while 158 is probably…

view full answer...

Answer 3

Yes, the batteries on the TST TPMS for RVs - Color Display - Signal Booster - 4 Flow Through Tire Sensors Item #TST-507-FT-4-C can be replaced with a CR1632 battery. You do not need to be moving for the sensors to be working, but the flow through…

view full answer...

Answer 4

You should air the tires up to the max PSI rating stamped on the sidewall of your tires, which in your case is 95 PSI as you mentioned. Trailer tires have a different sidewall construction compared to standard vehicle tires, and running less than the…

view full answer...

Answer 5

I recommend checking out the TST TPMS for RVs - Color Display - Signal Booster #TST-507-FT-4-C. This is my personal choice if given one because it's simple to use, and you don't have to remove the sensors every time you air up. It may not…

view full answer...

Answer 6

If you have valve stems with a metal body like the Americana Metal, Bolt-In Valve Stem part #AM20906 then you will want to use flow-through sensors but if you have valve stems with a rubber body like the Americana Rubber, Snap-In Valve Stem part…

view full answer...

Answer 7

The signal booster of the TST TPMS for RVs #TST-507-FT-4-C is required for use and would be needed with your setup that has a 35 foot 5th wheel. The exact range isn't listed but it was designed for applications just like yours so it would work…

view full answer...

Answer 8

When there is a tire with low pressure or any other anomaly there will be an audible alert combined with flashing messages to let you know what the problem is. Whether it's high/low pressure, high temperature, or fast leak. It will then tell you…

view full answer...

Answer 9

The booster of the TST TPMS for RVs #TST-507-FT-4-C that you referenced was designed to mount in the battery storage area like what you have mentioned on your Grand Design, so it will work great there and be able to communicate with the monitor in…

view full answer...

Answer 10

The TireMinder i10 TPMS #TM38FR refreshes every 6 seconds which would be the quickest option we have. I would agree that the 5 minute refresh rate of the #TST-507-FT-4-C is really long.

view full answer...

Answer 11

I reached out to my contact at TST and all of their TPMS systems like the TST TPMS for RVs - Color Display #TST-507-FT-4-C use sensors that are accurate to within +/- 3 PSI. This is a very minor variance so it is not something I would worry too much…

view full answer...

Answer 12

We actually have had customers make the swap from rubber valve stems to metal valve stems so they can use the TST TPMS for RVs - Color Display - Signal Booster - 4 Flow Through Tire Sensors #TST-507-FT-4-C. I added the cut out of that review for you…

view full answer...

Can The TST TPMS for RVs # TST-507-FT-4-C Ready A 0.1 % PSI

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching