Screws in the Cruiser Accessories License Plate Bracket are Too Long
Updated 11/22/2013 | Published 11/21/2013
Question:
The license plate mounting screws, when installed on this bracket, would pierce through the bumper. In other words, wish this bracket was significantly thicker or I could find screws that were half the length of normal license plate screws. Any suggestions?
asked by: Atul
Expert Reply:
A simple solution to this would be to use some washers between the screw heads and the bracket. This will shorten them up to the desired length. Otherwise shorter screws withe the proper thread type would work too. Washers and screws should both be available at your local hardware store. There are none that are specifically designed for this purpose that we carry.
Product Page this Question was Asked From
Continue Researching
- Shop: License Plate Bracket - Black
- Q&A: Can the License Plate Bracket # CR79050 be Used to Adapter Smaller Wyoming Plate to Standard Holder
- Q&A: Will the Prodigy RF Brake Controller Prevent a Trailer Mounted Battery from Charging
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Tekonsha Prodigy RF Wont Pair Troubleshooting with Mercedes
- Q&A: How to Choose a Trailer Hitch for a Trailer
- Q&A: Recommended License Plate Mount For Fender of Car Hauler Trailer
- Article: Determining Trailer Tongue Weight
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Q&A: 5 Pin Round to 4 Pole Flat Trailer Connector Adapter for Motorcycle Pulling a Trailer
- Q&A: Is it Possible to Use 5-Way to 7-Way Adapter with Trailer Brakes
- Article: Trailer Lighting Requirements
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: 5 Things to Know About Weight Distribution Hitches